Search results

Do you have a build thread?

Most of the offerings here have their own switch/dimmer. No affiliation.

Have you checked out the offerings from Hard Korr?

I also added the same between my ARB twin and Flexzilla hose. Given the trouble, I’d say that ARB hose looks pretty good.

Mind the heat if you’re pulling directly off of the compressor. The ARB hose is expensive because it can take it. Most regular air hoses are meant to take air from a tank and are not heat rated. Ask me how I know... ;)

Yes! So awesome!

I thought I picked up TotalBoat a while back as it was the budget option, but I went back and checked and it was $125! I don’t know what I was thinking... carry on.

That sounds like every Flippac support rod arrangement that I’ve ever seen (mostly in pictures), so I would say you’re being overly cautious... but, that geometry is what I have not seen before. Your idea of a roof cross bar may fix that issue though - you might be onto something there...

You may save a few bucks with TotalBoat epoxy, if it’s slow enough for you. I know Raka is used when it’s hot or when you need a super slow cure time though...

I just did this as well, so I’m no expert. I set the lid so it was a straight line with the rear/bottom half of the shell. I’m pretty sure you need the support rods to hold the lid both down and up. Do you have the support rods and hardware? If not, they are reproducible, but the hood...

Much appreciated. Thanks to you both!

I had a very similar thing happen to me on a dirt road in Baja. Saved by a fellow traveler that had way more hub/bearing experience (and advice) than me. I generally stop for anyone in the wilderness on the side of the road just to make sure they’re okay. I’ve only been able to provide tire...

Sorry to the OP to hijack this awesome thread, but I have a question that may or may not be relevant. I have recently replaced a traditional truck shell with a Flippac. The shell had clamps that were installed by the dealer and now I have installed the Flippac with through bolts into the bed...

The link you provided has it for $239 with free shipping.

Upon closer inspection, I see the drain setup better. I’m sure it’s all sorted just fine, but still makes me nervous and you’re right about that cabinet on the right side of the pics.

How is it acceptable to place the batteries under the shower pan? Honest question.

We just called our trailer “the boat anchor”. It definitely changes your perspective on mud, sand, snow, etc. We became more accustomed to turning around and changing our plans on the fly. We ended up rigging our trailer with a Chinese diesel heater after only a single trip with the Mr. Heater...

Avenza. It’s free, has free USGS maps, and it’s what the Forest Service uses for their maps (like MVUMs - also free). There are maps available that you can pay for too. iPad in the truck, iPhone for hikes.

Hey... I was distracted by the pretty pictures... ;)

Very nice. Where is the combustion intake routed? Are you going to go with no muffler?