Search results

  1. MojaveMadMan

    Little Bit of Everything 3rd Gen 4runner - MojaveMadMan Edition

    At this point I had stacked up quite a few items that needed to get installed. Here is the list of what I had collected. - Front Diff Fluid Change – Lucas 85W-140 - Transfer Case Fluid Change – Mobile One 75W-90 full synthetic - B&M Transmission Cooler - Removing the stock cooler for now (until...
  2. MojaveMadMan

    Little Bit of Everything 3rd Gen 4runner - MojaveMadMan Edition

    Next on the list was the Big 3 wire mod, also done using BFAD’s write up. I noticed that there was some corrosion on some of the main wires and I decided that I should go ahead and do the Big 3 now so that I can avoid some future problems, and so I would be prepared for future mods. Again I...
  3. MojaveMadMan

    Little Bit of Everything 3rd Gen 4runner - MojaveMadMan Edition

    So the next thing was the drive from CA to NM. All went well with zero issues. Started daily driving this pig and it was doing good. I was eager to get moving on this thing, I had it for about 5 months at this point and hadn’t been able to do much to it. I spent a lot of time trying to decide...
  4. MojaveMadMan

    Little Bit of Everything 3rd Gen 4runner - MojaveMadMan Edition

    So here is the start of the build! This was in Valencia, CA. I was stationed in CA before NM. I picked this thing up in the ghetto down in Los Angeles for $4000. It had a CEL, and the guy had mentioned he had some charging problems he fixed with a new battery and alternator, and he had recently...
  5. MojaveMadMan

    Little Bit of Everything 3rd Gen 4runner - MojaveMadMan Edition

    First of all thanks for checkin out my build. I have been a lurker on here for a while, finally time to share. As is customary I will give a little background about myself, plans for the build, and then you know what follows. I also have a build thread on Toyota-4runner.org, but that site is...
  6. MojaveMadMan

    Thoughts on Off Road Bumpers?

    I like this one, almost looks factory but provides a little protection if you hit something head on. The only issue I see is if you hit something on the corner, or something bigger that will go over the top of it. I am sure you could get creative and help address these areas. Or as other...
  7. MojaveMadMan

    Thoughts on Off Road Bumpers?

    I never understood why you see so many people building big 1/4" plate bumpers, or even 3/16" for that matter. For overlanding specifically, or even alot of the recreational folks that is a lot of steel for the off chance you might come into contact with something. I personally am building a...
  8. MojaveMadMan

    2nd Gen Tundra On The Move

    very cool spot! Good luck with your build.
Top