Search results

its a hinge with bearings....its the MEGA-DUTY HINGE KIT (i.e. the 1 1/2" spline option) from A-Z Fabrication: http://www.atozfabrication.com/store/Tire-Carrier-Swingout-Heavy-Duty-Hinge-Kit.html

here is a picture of the stopper. the T-handle is spring loaded so it ride on the metal semi-circle until it encounters one of the hole and then it drops in to stop it. I have two open postions: (1) just enough to open the rear hatch and fold-down and (2) open a little further to get the tire...

Unfortunately no. The guy on lrrfoums was going to produce 20 of them, but the fab shop wasn't precise with following the prototype and they wanted him to cover the cost for their mistakes, so they parted ways. The reality is the test fit unit I purchased from him was ~60% complete and needed...

Thanks! Yes, its the stock plastic bumper cover that goes over the bracket and metal stock bumper. Had to cut two holes in the bumper cover: (1) small one for the striker bolt that locks the arm closed with the dual rotor latch mechanism and (2) larger one for the arm hinge.

I finally completed the rear tire carrier for my LR3. The carrier started as a partially finished unit from 05lr3guy on lrrforums (who was attempting to produce 20 of these). I was lucky enough to pick up the 'test fit' unit the fabrication shop shipped to him for test fitment before they...