Search results

That must be an XLS? Different dash setup than a Limited

I did this instead. Gives a little extra space to get the Trasharoo straps around the tire easily too.

Did you buy the entire HBB or just the motor?

NOS - new OLD stock

That is not going to work. This method is a 2 person job. After the brake pedal is depressed by person 1, the bleeder screw needs to be closed (tightened) by person 2 before releasing the brake pedal by person 1... Then repeat, open bleeder, depress pedal, close bleeder, release pedal, repeat...

I have not read back in this thread, but have you reviewed the FSM procedure for brake bleeding?

I use a couple of these: https://www.amazon.com/gp/product/B01HPTMDBW

Mine was removed several years ago, it was not louder with the stock muffler. I now (3 months ago) have a Flowmaster 40, truck is slightly louder than stock. I had a full CAT back exhaust built by a local shop.

https://stellarbuilt.com/ Not sure where these guys are compared to you , but they support the Montero community.

20 watts each? Do they really deliver 80 watts for the 4 units? Portability is cool if they put out. Are they the same as this one: https://www.amazon.com/Goal-Zero-Nomad-Solar-Panel/dp/B00GU64KV8 How does this compare...

I did Amazon last purchase, and TireRack before that

I like these, searched for a long time for a low miles 6 speed. gave up. Too few available. Look at Joying car audio. Amazon\ebay, I just bought one for the '05. https://www.ebay.com/itm/JOYING-Aftermarket-7-Car-Stereo-Radio-GPS-Double-Din-Bluetooth-WiFi-Android-8-1/332526364232

oh geez. I'll stick to regular holders and welding

Being there is nothing holding the caps front to back, I'd be seriously concerned that vibration would allow those things to separate from the batteries causing loss of contact. They do not look robust at all.

sounds like a good $2k vehicle at most

I'm a bit confused reading this statement. Are you saying that the 3.5l \ 3.8l from the Gen 3 trucks won't swap into the 97 - 00 trucks? I think I understand this correctly.

OK, probably similar as the one I have (Tab2 A10) , am looking for a refresh. Was wondering if it was a Tab 4 perhaps and how fast it is. The Tab 2 seams to be slowing down a lot.

What model Lenovo?

Its quite a bit of torque on that bolt. Not sure why they would say 3x is OK. It should be replaced with every timing belt job. Assuming that is the only time the bolt is torqued.

Just remember if you are paying someone to do the labor for the front shocks, its a bit involved, book rate around 4 hours to do both. So the labor charge will be considerably more $$ than the cost of the springs (in my neighborhood anyways).