Have a look at Pickles.
A good looking crew cab with only 23ks on it.
https://www.pickles.com.au/facet-search#!/search-result?q=(And.All.keyword(canter)._.Salvage.non-Salvage._.ProductType.Trucks.)&startPage=1&scrollPosition=805
Also try put the transfer case in neutral while the engine is running and go though the gears in the gearbox .
Have a look at the center bearing too.
Any different with the Free wheeling hub in or out?
The seal will be on the inner not outer , there is a gasket on the free wheeling hub that is pretty easy to make or reuse the old one.
Seal should be 72mm x 96mm x 8mm and total with lip 12mm
Seals for front wheel bearing for a repack or front wheel bearing kit if you need them to be replaced.
A good pair of circlip pliers to take the circlip off the drive axle.
Wheel bearing grease.
Brake shoes, brake cylinders.
Degreaser ,gloves and dont forget hand cleaner lol
Its not a bad job...
Shifting into or out of 1ST gear?
I very rarely use 1St most of the time take off in 2nd.
Does it change into all other gears ok?
Any clutch fluid leaking from master or slave cylinders??
Good old truck
What rims?
5 spd box?
1st gear may not have syncro ???
As you would normally take off in 2nd gear it may not cause too much trouble ,change the gearbox oil and see what it looks like.
Look under the floor mat for rust .
is he open to offers???
Sand flags for The Simpson?
I want to put a sand flag on our roof rack not on our bull bar but as per the rules sent below it should be 2m above the roof.
Now that will make it bloody high what has everyone been doing????
1. Every vehicle must have a sand flag
Specifications:
Minimum 300mm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.