Search results

Sold

Sls

Got an hour to work on the camper today, finished up the fridge portion of the storage. Used a cable chains to guide the power cable in and out. Turned out nicely. I also got another 8020 section installed through the floor. Now I have the measurements needed to start my floor finishing...

Sold

Covercraft rear seat covers for 2013 era Outback. Waterproof gray colored. Located in Denver metro area $100 shipped

Worked some today on installing a renogy 160w flexible solar planet. I used industrial outdoor extreme Velcro to hold it down. I need to add a smallwindbreak on the front of the panel.

Worked on the fridge slide more today. I was taking off all day to work on the truck but of course work emergencies happened. But I have the skeleton done and most of the panels made up. Think I’ll head to Home Depot tomorrow to get the shelve and top for the fridge slide.

Worked some more on the interior of the camper. Ran out of 8020 fittings, so cut a bunch of parts cut and made up. The final assembly, minus the panels should go pretty quickly. I am not sure if I like my latches yet. The reason the fridge is so high up is to leave clearance for the propex...

The aluminum rail is both bolt through and i am using riv nuts through the bed too to attach the rail and other accessories / mounts to the bed. The tailgate door, i'll probaby get a tailgate seal off of amazon, and have thought of going with converting the whole rear door is one piece. That...

wish you were in denver

How about for your landcruiser Chase......

Small work, bigger step today. Installed the passenger side floor tie downs for the cabinetry / fridge slide. Hoping to have some time after work and get the fridge slide skeleton done this week.

Feeler for trading my 2000 4Runner for a land cruiser 100 or gx470 Details: -143k miles approximately -3 owner (1st was leased, 2nd owner had it from 04-18 -Colorado : mostly Denver metro area vehicle -no rust Maintenance: -timing belt / wp around 125k miles -radiator replaced with oem at...

Also have three ram mount phone brackets. Used in three cars with a 6s. Just upgraded to a 8+ so it won’t fit. $30 shipped obo for all three

Worked on a side panel for the heater, used a little too many fasteners to keep it attached to the framing.

Worked on the heater some more today. Made some vent brackets for the upstairs vent, and made a temporary heater inlet with some scrap I had laying around. Now I can start working on the fridge slide and getting that perfect and nicely tucked in.

So I have a bunch off odds and ends I’ll be posting on here while working on my ovrlnd camper. I am also cleaning out random truck stuff from the shed too. All located in Denver, and will ship most. -Propex 2800 stock exhaust and intake (new) $20 obo -misc lift strut parts (10mm studs, 4...

Finished picture of the thermostat / controls. Also worked on some new Yakima bar roof rack mounts for the tracks on the roof.

Worked a little more today on the propex heater. Got to run it for the first time too. Electrical, propane, exhaust, intake, and propane alarm are all done. Also added a little insulation before I finished the mounting . Just need to do venting and CO alarm.

I have the right valve ordered along with some other fittings to finish the gas line and get the second hose custom length crimped.