Search results

Very interesting article on a new breed of lighter than air-craft. Right now the money behind the programs is coming from the military, but there is huge potential for reducing pollution, reducing cargo freight costs, reducing number of runways, etc.

I know you can do it Jim. I'm 100% behind Travis on the pink tassles, can you get them to rotate in different directions?

National Luna is the way to go. We have kits here.

Jim Doesn't Travis get a little basket on the handle bars in case he goes shopping?? :sombrero:

Interesting, I've never had a problem doing it this way on several vehicles using different couplers.

It's not an issue, so long as you have the recommended clearances around the fridge. The temperatures inside a trailer are typically lower than those found inside a vehicle. A few caveats. We are talking about 45-60 liter compressor fridges The fridge is located in the main box The main box...

The bushing on the max coupler is a very tight fit and it can be a challenge to align the two halves. We find that dropping the trailer side into the vehicle side is easier if it's done from the back and then move forward to the pin location as it's dropped down. An easier method of detaching...

Enjoy my friend.

State of the art, hand built, quality product, usually is :)

AT is now having the boxes for the Portable Heater made out of aluminum by a local craftsman. The boxes house an HS2000 heater that puts out 6483 BTU. Included in the portable kit is the thermostat, 5ft of reinforced exterior grade air duct, 12 volt power cord, and two stage regulator with 5ft...

This one.

You can see our current schedule of events for 2011 either on the contact page of our website, or on our Facebook page under the "Events" tab. We will have a JK Habitat at all of these events. The list of events is not complete yet, but as you can see its a very full calendar.

If you have a thermostat in the tent then the fact is a large heater is really irrelevant. The heater will turn on and off predetermined by the thermostat setting. To give you some idea of heating capacity, we use the HS2000 it generates 6483 BTU and heats up a RTT very quickly, with the...

An other option is to build a 2' receiver tube into the tongue of the trailer. That way you can slide in a Max Coupler, ball coupler, or lunette eye. There is a report on how to modify a M416 at the Jeep Brokers website. AT has some of the tongue plates needed in stock

For propane heaters its essential that the units be jetted correctly. Many marine furnaces and standard furnaces are set up to be operated at sea level, so they need to be re jetted for elevation. The HeatSource furnaces we use have been adjusted for elevation and operate at elevations up to...

Don't you think body roll is also a function of bag height ?

The block heater on the 7.3 warms both the water and the oil, which helps enormously. If you get a generator make sure it's producing enough power for everything. The block heater draws 1000 watts (around 8.5 amps), a battery charger will be 6-10 amps, plus anything else like a battery blanket...

A few thoughts for you. There are a couple of techniques for 7.3 diesel starts in cold weather. Turn the key to the on position and let the glow plugs heat up for at least a 1 minute before attempting to start the engine. Your chances of starting are much greater if you do so. If you try...

From personal experience I can tell you that putting up and taking down a traditional single trailer tent can be a major pain in comparison to a standard roof top tent. You are typically looking at a 5 minute job for a RTT vs. a 20 minute job for a trailer tent. Obviously the length of time...

I think your looking at "potting" or encapsulating" the circuit boards. There are lots of materials for doing both, do a Google search for potting or encapsulating circuit boards or Potting Solutions. The materials work well to keep the elements out of the circuit boards, but only if the board...