Search results

Toyota's prices for most shops on the Valve grind kit is 220(my cost on this kit) or more. You can buy just a HG on it own. But I have never got just a HG due to the other parts needed to install at the same time. Now most of the Aftermarket HG kits I have seen are still using the original...

It is a paper element still. I like the fully synthetic medium that the Toyota Filter has, no paper to mess up. No real need for a big filter like the 41010s, unless it is a paper one that can go 10miles as well. Pretty soon, it may be the only option I would buy for my cruiser(as it is harder...

I did a quick search on Mud for oil viscosity chart and looked for a couple of minutes. There are a few threads on this subject from the past that will fit your needs. But I did copy this below for a tease. I got the AU viscosty from Andrew at 80school 1fzfe motor 20w50 oil- -7 deg to...

Witchhunter.com does just as good of a job on the injectors as does RC, and for a bit cheaper. They also send out a sheet of paper that shows you what the injectors were doing before and after. They turn them around in short order as well. After the machine shop gets done with her, and...

One potentional problem is the bushing for the oil pump drive gear. It must be removed if you hot tank the block, this bushing is not a dealer item or off the shelf item. It can be a bugger to remove as well. It can be reproduced if the machinest is willing. This machinest is in texas. If...

Well Jermery(I hope I remembered right). That is a mild case of predetonation that happened(you should see what a bad case is). If that was not there when you blew the head gasket. it happened when LC tried to tune the truck with the new HG on it. It is fairly common with these S/C'd trucks if...

About the only way to increase the fuel ecomony on the 3fe 80 is to rework the engine. If you do your own work and are confindent that you can work on engines, remove the head, decarbon the engine. Have the head work done, mill off.030 to .040 and put it all back together. This will wake up this...

Point of reference, the manual shift t-case can have the same problems as this one as well. If the ball switch does not work, the ADD does not work. So unless you opt for the full time system on the FJ, you can have the same problems this gentleman is having. Ball switches have been in the...

Before I would pull the front diff, I would look at the sensor that tells the computer that the t-case is locked I have seen this sensor fail in many different models(toyota same share parts). It is a ball switch and unlike the older model switches, it has a long pig tail on it. It typically...

I replaced a fuel tank not too long ago. It really is not that hard. But if I remember right I had to remove the drive line to have more room. I can lay under my truck tomorrow and see what I remember what I did. As for a fix, Welding is the way to go for permanet fix, unless you find a...

One place that is not mentioned to buy tools is Craigs list or your local pawn shop. Used high end tools(snapon, matco, proto, craftsmans) can be had for a fraction of the cost new. Then they can be repaired by the truck guy. For Torque wrenches is will not pay to buy cheep. Buy a Snap on or...

For the 20004's Contact Dan at american toyota. He was/ still is able to get them when he runs out of them. He has some special conections. You can contact him 800-432-6668. I have not recently talked to him as I have a case of these filters at home. But I know from past conversations he was...