1975 F250 Highboy Crewcab 4x4 Project

[sokoloka]

New floorpans have already arrived but honestly they're not as bad as I was expecting before the rubber floor mat came out.

 

[Mekcanix]

Congrats on getting Married!!!!!!!!!!!!!!!!!!!!!!

 

[sokoloka]

Congrats on getting Married!!!!!!!!!!!!!!!!!!!!!!

Thank you!!

 

[sokoloka]

Eric on Instagram: "BACK ON THE ROAD! Lots of blood, sweat, gears - sticker on the plate says it’s been thirty years! 1975 F250 Highboy Crewcab. #cantfinditgrindit #ford #fordhighboy #f250 #highboy #4x4 #trucks #trucksofinstagram #chasetruck #dents

143 likes, 5 comments - cantfinditgrindit on December 29, 2023: "BACK ON THE ROAD! Lots of blood, sweat, gears - sticker on the plate says it’s been thirty year..."

www.instagram.com

Hope I'm doing this right ...!

 

[Trektor73]

Based on your Instagram, did the Tremor get traded for a Raptor R?

 

[sokoloka]

Based on your Instagram, did the Tremor get traded for a Raptor R?

Raptor R was an addition to the stable - still have the Tremor for towing purposes.

 

[sokoloka]

Little morning glow looks good on everyone!

 

[Kingsize24]

Jesus!!! Hit me up when you are ready to sell it. Love it man!

 

[sokoloka]

First round of updates from project rust replacement:

Figure might as well tackle underneath the rear bench at the same time, luckily nothing too major there it seems.

 

[sokoloka]

Some more progress before the rain shut everything down.

 

[sokoloka]

More the merrier right? Picked up this 1974 2wd shorted crew over the summer, finally shipped it down from Montana this week. Turns over smoothly and got her briefly fired but lots of fixing on to do.

 

[Kingsize24]

Shortbed crew is hard to find around here. And you are popping up with them like mad.

 

[sokoloka]

Shortbed crew is hard to find around here. And you are popping up with them like mad.

Can't save them all but I'm trying!

 

[sokoloka]

Some more progress in the rust repair department ...

 

[Kingsize24]

Not as bad as I was expecting. You going to replace the entire lower surround? Or just pan it and rust convert what's there?