Greetings everyone! I am doing a build (that I will share soon enough with everyone) and the roof/front of the trailer exterior are a single sheet of 4x8 aluminum bent to 90 degrees and placed on a 2x2 square steel frame.
My question is, how should I secure the aluminum to the steel?
Rivets, epoxy etc....
I am aware of the corrosion issues when combining the two but I will be coating them before mating them together.
I am mostly concerned about the expansion/contraction of the aluminum with the temperature and possible rippling and tearing due to the method I will be selecting to affix it to the frame.
Oh, it is about 16ga. Aluminum.
Suggestions?
Thanks everyone!
My question is, how should I secure the aluminum to the steel?
Rivets, epoxy etc....
I am aware of the corrosion issues when combining the two but I will be coating them before mating them together.
I am mostly concerned about the expansion/contraction of the aluminum with the temperature and possible rippling and tearing due to the method I will be selecting to affix it to the frame.
Oh, it is about 16ga. Aluminum.
Suggestions?
Thanks everyone!