MountainBiker
Experience Seeker
Good luck with this! It took my Toyota dealer 2 tries to get the axle seal replaced properly (under warranty). I suppose on the 2nd time they followed the TSB and assigned the experienced tech!
Fat_Man said:Well, they say it is ready to pick up. I hope this time they got it. It sounds from what they are saying that they covered all the bases as far as checking alternative issues, like clogged breather, bearings, axle shafts, so hopefully, whatever/however they did it differently this time...works....
Fat_Man said:Anybody else had issues with their axle seals?
taco chaser said:You might have blown wheel bearing causing seal failure if there is fluid on your brakes. One other question was the bearing replaced before this problem started?
Fat_Man said:I had bearing issues, but I believe it was only the front bearings replaced. Since this last attempt at a fix, though, it has not leaked, and it has been about 4000 miles, one Trophy event, and now about 3 weeks later, and it has not started leaking again, so at this point, it seems that they remedied whatever they were doing wrong upon install.[/QUOT Sometimes when replacing the rear bearing people tend to press the seal surfaces and the ABS ring to the wrong points on the axle, just a little to far in or out and no seal. I'm glad those monkey's fixed the problem.