aux. back up lights

[JohnMcD348]

I like that setup you did on The Ram. I've thought about doing something like that with my MegaCab. What lights did you use and how sis you cut the holes and mount them? I've seen it on a couple of other Rams in the past but never been able to figure out how they actually mounted the lights so cleanly.

 

[JIMBO]

:sombrero: Heh Heh, thanx and I have a backup camera to--but

That is a good way to do it. No need to blind everyone in camp.

At bit OT, but for off road I like the backup camera off the backup circuit too.

It's mounted on my trailer and comes on, when I flip on the driving lights !!

This is an old pic, but look at the top of the license plate, that black horizontal bar--is the camera--

Kewl, I can see short trees when I'm backing up !!

:costumed-smiley-007:wings: JIMBO

 

[LexusAllTerrain]

:sombrero: Heh Heh, thanx and I have a backup camera to--but




It's mounted on my trailer and comes on, when I flip on the driving lights !!

This is an old pic, but look at the top of the license plate, that black horizontal bar--is the camera--

Kewl, I can see short trees when I'm backing up !!

:costumed-smiley-007:wings: JIMBO

Freaking bad *** set-up!

 

[UNI]

I have a Hella #996 136-231 LED MegaBeam Deck Flood Light mounted on the roof rack, wired directly into our Jeep backup lights.
Only comes on when backing up. Its BRIGHT, REALLY BRIGHT!

 

[sapper]

I like that setup you did on The Ram. I've thought about doing something like that with my MegaCab. What lights did you use and how sis you cut the holes and mount them? I've seen it on a couple of other Rams in the past but never been able to figure out how they actually mounted the lights so cleanly.

All I used was some tape to mark on the bumper where I wanted them and reduce paint chipping. I then used just a standard 4.5" hole saw. Took about 15mins start to finish not counting mounting the relay behind the factory tail light.

I think I have all in the info in my build up.

http://www.expeditionportal.com/forum/showthread.php?t=44648

 

[JohnMcD348]

Great. Thanks for the link. I'll look for the trailer grommets in my local parts store. Once I find them I can see my next new mod. I may even do it to the Bronco also.