Before I pull the trigger...

[marathonracer4]

Ok so heres one of those questions that you search and search for but never really find the exact answer... so before I get in to deep I have a 03 Taco and will be putting 2.5" of lift up front 2" in the back. Will 33 1050 15 BFG KMs mounted on 15" wheelers type B (4" BS) fit. Also with these lift amounts will the truck be level?

 

[Off-Grid Engineering]

yes, the tires will definitely fit. I have seen this combo a few times. and yes, the truck should be about level. however, everyone's truck is different.

 

[Rattler]

You may have to do some plastic inner-fenderwell trimming. I am running 32x11.50 Kumho Road Venture MTs with Wheelr's 15x8s on my '04 Taco DblCab on about the same lift in front and I still get occasional rubbing.

 

[Clark White]

I run 33x9.50. I had to do some decent hammering (with a small sledge) to the pinch weld at the rear of the fender, but other wise there should be enough room for the 10.50 (at least I hope, because that's my next tire!). I have had problems with the right side rubbing the frame, even with the 9.50, but I think that is due to alignment problems as the left side has LOTS of clearance off the frame.

Clark

 

[Go4Lo]

Check out my thread:

http://www.expeditionportal.com/forum/showthread.php?t=26718

I just put 33x10.5s on my 01 Tacoma. I have 3" of lift up front and 2.5" in back.

I had to trim the pinch weld up front and used the Sky Mfg. relocation plates to move my rear axle 3/4" forward. I'm running 15x7 Cragar soft 8s with 4" backspacing.