Indestructable fender flares

BigTaco

Observer
Found these while crusing the web...

Ironpigoffroad

Tired of tearing up cheap poly flares? Time for a set of IPOR's new indestructable fender flares!

Made from formed 1/8" plate steel these flares are suitable for pounding on trees and rocks.
The 1/4" back plane can be drilled & tapped for a no-weld installation.
Cut-out maximizes body protection and tire clearance. (shown here with a 37" IROK)
Sold in pairs, one left side and one right side
Limited time only - $349.95
 

adventureduo

Dave Druck [KI6LBB]
What happens when you snag them on rocks now? It bends the side of the body with it?

I'll stick with replaceable plastic flares. I think of them as 'quick-release'.
 

ntsqd

Heretic Car Camper
Wonder how much they weigh?

I could see tying them into the cage, ski's, and rear bumper of a crawler.
 

Photog

Explorer
SOCALFJ said:
What happens when you snag them on rocks now? It bends the side of the body with it?

I'll stick with replaceable plastic flares. I think of them as 'quick-release'.

:iagree:
Yea, these would need to be tied into the substructure somewhere, as they are so much stronger than the sheetmetal they would be attached to. At this point, they would just move the damage from the flare to the fender. Flares are cheaper to replace.

They do look better than tubes running around the wheel wells (ARB or TJM etc.).
 

Rezarf <><

Explorer
I think they are sweet and honestly, not THAT much more than a peice of plastic...

... I think they are more for scraping on trees and rocks, I would bet they would work great with the load spread out over the entire fender flare.

Just another .02

Rezarf <><
 

Forum statistics

Threads
189,936
Messages
2,922,410
Members
233,156
Latest member
iStan814
Top