enigmaoperator
New member
Nice work!!
JDM LN107 Hilux build thread
- Thread starter Ray_G
- Start date
enigmaoperator
New member
Where / How did you mount your ARB compressor? I saw the switch on your center console but didnt see the compressor under the hood
Ray_G
Explorer
Air compressor switch was a pre-wire setup for eventual compressor either in the bed or maybe under it. No real room under the hood. I want to get to OBA but have been swamped so the truck just gets used as is.
Sent from my iPhone using Tapatalk
Ray_G
Explorer
Minor updates. Some refinement to the rear setup:
Added in the track for less warping in the sun and eventual add on.
After about six months of running the turbo as-is, with no major issues, I did decide to start doing a few mods on the fringes for longevity.
Turbo blanket
Along with some reflecting wrapping on the intake to mitigate heat there.
Neither produced dramatic results, though EGTs did seem to go down slightly on the long hill pulls.
Big project coming up is a baby air to water intercooler.
Sent from my iPhone using Tapatalk
Added in the track for less warping in the sun and eventual add on.
After about six months of running the turbo as-is, with no major issues, I did decide to start doing a few mods on the fringes for longevity.
Turbo blanket
Along with some reflecting wrapping on the intake to mitigate heat there.
Neither produced dramatic results, though EGTs did seem to go down slightly on the long hill pulls.
Big project coming up is a baby air to water intercooler.
Sent from my iPhone using Tapatalk
ln107yank
New member
Small update.
Truck stock oil pressure gauge never worked. During turbo install and subsequent alternator fun it became apparent the sensor was unplugged. Specifically the wire had been cut.
After a lot of fun finding a Toyota 1/8 28 BSPT threaded tee and such, along with a 45 adapter for the tee to provide sufficient offset, and then getting everything tight and sealed despite the aforementioned lack of clearance but FINALLY:
And now...the idiot gauge works.
May eventually explore aftermarket temp gauge and such but for now this is at least more info than the day before.
Sent from my iPhone using Tapatalk
Looks good! Have the same kit from HD Auto and hit the snag with the oil pressure tee, can you share where you sourced the tee? Everything is NPT that I have found!
Ray_G
Explorer
Ah, from what I remember we didn’t run into issues because I sourced the combo gauge from AUS too: