Just got an M101A2, hitch question

[TKM101]

I'm new to the forum, so let me know if this is the wrong place to post.

I just purchased an M101A2, I don't like the hitch it has, with the hydraulic brake actuator. I don't mind the Pintle Hitch, but I've seen other models with a lower profile hitch, this one is just big and bulky and I'm going to want a different trailer tongue jack wheel anyway. I'm going put the Timbren axle-less suspension so the Hydraulic brake actuator isn't needed.

This is my M101A2

This is my hitch
This is what I would prefer, something not as bulky, can purchase this piece to just unbolt the other and bolt this one in or will I need to weld something if I want a different hitch?

Any suggestions would be great as I am new to this whole process.

Also, what does one of these usually go for? ( just want to know if I paid too much haha)

Thanks!

 

[wADVr]

I would look into this product and see if the angle and mounting holes mach the M101. It looks close if not perfect from the pictures.

M416 Trailer Receiver Tube Tongue Retrofit Kit by Dinoot Trailer Racks

Upgrade your M416 trailer with our M416 Trailer Receiver Tube Tongue Retrofit Kit. This innovative accessory empowers you to effortlessly extend the tongue length.

compactcampingstore.com

I made my own very similar to this and used a MaxCoupler set up. Have liked it and saved a bunch of weight. Can also buy a lunette ring that has a 2” tube on it to adapt to the product I linked above.

 

[TKM101]

I would look into this product and see if the angle and mounting holes mach the M101. It looks close if not perfect from the pictures.

M416 Trailer Receiver Tube Tongue Retrofit Kit by Dinoot Trailer Racks

Upgrade your M416 trailer with our M416 Trailer Receiver Tube Tongue Retrofit Kit. This innovative accessory empowers you to effortlessly extend the tongue length.

compactcampingstore.com

I made my own very similar to this and used a MaxCoupler set up. Have liked it and saved a bunch of weight. Can also buy a lunette ring that has a 2” tube on it to adapt to the product I linked above.

Unfortunately its a different angle or that would have been perfect.

I would like to find something like this :

504 - V-shaped, industry standard, 50 degree bracket. | Lock N Roll

V shaped coupler on industry standard 50 degree bracket. This is a very rugged unit that has holes for your jack stand. Weld on and/or drill and bolt this to any trailer with a standard V shape tongue.

locknroll.com

But the trailer is about a 30 degree angle so those won't work either.

I'll probably just have to get something fabricated.