high-and-dry
Active member
I am going thru this right now as well. The main reason for using the spacer is it lets the center cap fit, if you look at the pic Mischief posted above you can see the grease cap is out to far.
Also using the spacers would allow you get the spacer nicely lug centered and tight then the rim will hub center on the spacer if it has one. Some dont.
Edit the adapter rings some one posted above, Being less than a half MM off I bet you could do the old chill the hub heat the ring trick to get it on. Thats how they used to do bearing races when they did not have a press. NIce thing is once they are on they would not come off.
Also using the spacers would allow you get the spacer nicely lug centered and tight then the rim will hub center on the spacer if it has one. Some dont.
Edit the adapter rings some one posted above, Being less than a half MM off I bet you could do the old chill the hub heat the ring trick to get it on. Thats how they used to do bearing races when they did not have a press. NIce thing is once they are on they would not come off.
Last edited: