Move bumpers

[gator70]

Is anyone building them. I plan on one for the Isuzu. We will have to modify it.

 

[SkiFreak]

Interesting concept, but given that they do not make any bars specifically shaped for Fuso or Isuzu trucks, I feel that there would be a considerable amount of effort required to make one of these bars fit and to look good.
Maybe I am wrong, but that's my first impression.

 

[The Artisan]

Check out my Jeep Jk I installed on my fuso just a little fabrication
Kevin

 

[gator70]

The cabovers have a flat frontal configuration. The ford kit is more tapered on left and right. Considering a sizable mounted winch in the front, the differences are less than seen on the first glance. The Isuzu is about 81 inches wide and the American trucks are a few inches narrower. When buying a kit in parts, yet to be welded, addition parts can be fabricated to increase the width.

 

[SkiFreak]

FYI... all of the winch setups I have seen on the Fuso and Isuzu trucks have been mounted in a sturdy steel cradle that is bolted to both chassis rails, not directly to the bumper.
Just sayin'.

 

[gator70]

Thanks for the tip - Must consider water build up

 

[gator70]

On the other hand - the imported ones are way too inexpensive

 

[SkiFreak]

the imported ones are way too inexpensive

Quite often you get what you pay for.

 

[gator70]

I was very wrong about Move bumpers, just wrong for my application

 

[Ferjablito]

here in Spain in 3mm steel for less than 3000 euros you can't get anything, I would rule out duralumin for a defense