Need photo: Fleetwood Neon Crankshaft

[pokealong]

Hello,

Fleetwood Neon...The drive hub extension connector fell off when I was on the road.

Could somebody take a picture from underneath their trailer so I can see what it should look like? I can't find parts anywhere so I'm going to have to manufacture my own..I did find the schematic and part numbers, but apparently there are none to be purchased.

Below is the photo from under my trailer.

Here's what it looks like where the crank goes in.

You can see that there is nothing to put the crank into. I think that the extension is really just a guide for the crank, so I'm pretty sure it won't be hard. But I would like to know what it should look like underneath there.

thanks in advance for your help. My trailer is a 2007, but I don't know that that would make any difference.

 

[Steven.gresham]

Have you checked out Coleman Popup Parts?

 

[Sno Dawg]

Sending you a PM

I have a Fleetwood Neon and will take some pics for you.

Sno Dawg

 

[pokealong]

View attachment 480565Have you checked out Coleman Popup Parts?

Hi Steve,

It looks like you are also missing the drive hub extension. How are you cranking it up?

And yes, I have talked to all of the usual suspects!

Lynn

 

[Steven.gresham]

Hi Steve,

It looks like you are also missing the drive hub extension. How are you cranking it up?

And yes, I have talked to all of the usual suspects!

Lynn

There’s a linch pin that is in the place of the extension. It requires a longer crank handle but works fine.

 

[pokealong]

There’s a linch pin that is in the place of the extension. It requires a longer crank handle but works fine.

Taking a guess that your trailer was mismanufactured as was mine...take a look at this document I wrote up, which has pics of what mine looks like and then what it should look like...along with the parts schematic...

 

[Sno Dawg]

Here are the pics I took last night from my Neon - I hope they help.

Sno Dawg - Jeff

 

[pokealong]

These are great! Thanks!