Need tie-down flexibility-- L track

[Ryanmb21]

Nice work right there ^^

 

[paddlenbike]

Nice work right there ^^

Thanks. One thing I opted to do was install a small 2x3" 16 gauge steel backing plate between the body and the nut on the bottom. It's more reinforcing than the factory used and if you were in a really bad accident it would help prevent the nut and washer from pulling through the floor.

I need to hit the entire wheelwells with undercoat now...judicious use of the high pressure nozzle in the wheelwells after trips has really thinned the factory stuff.

 

[Adventure Copan]

I bought mine from Mac's and I've been really happy.

As for them getting clogged with coffee, I wouldn't worry at all. Don't cap the ends and it will fall out when sweeping or blowing with air.

Right on. Hoping to start on this in the next few months!