New or good used leather for Gen II driver side?

[quailchaser]

I picked up a bouncy seat base a while back. Now I have a Gen 2 manual seat (cloth) to use, but it is pretty dirty and greasy. I'm not sure if it will clean. My Gen 2.5 is power leather, so it won't swap. Anyone have a source for a new seat cover for a manual Gen 2 driver seat?

If not, has anyone ever tried to make an adapter for the Gen 2.5 power set pan to go on a Gen 2 bouncy base?

 

[evol911]

I recently put a bouncy in my SR with leather. If you have an upholstery shop close by, I don't think it would be to hard for them to stretch the leather cover over the fabric seat pad. Then you just pop two holes in each side for the manual seat back frame to bolt up and you should be good to go. The leather upper seat cover/pad will fit over the manual seat frame.
I left the my seat with a fabric bottom and leather upper. Maybe you can find another seat cover(cleaner) if you don't have an upholstery shop around.

 

[nckwltn]

You can transfer over the seat back onto the bouncy seat back frame. IIRC the foam is the same, but the power seat has a power back. Not too difficult but you will want a couple pairs of needle nose pliers. Doesn't solve the seat bottom problem, but might save you some $$ at the reupholster

Sent from my A0001 using Tapatalk