penski61/sexy6chick's 02 SAS
- Thread starter penski61
- Start date
Stan the Man
Adventurer
sick build.
penski61
Observer
alot of things have been done since the last update
installed toyota rear leaf springs up front and one leaf from the old leaf pack
installed custom valved fox shocks along with limit straps and relocated bumpstops
installed 10" travel driveshaft
moved the gas tank from under the truck and into the bed , possible 4 link in the future
Slip yoke eliminator
moved everything back to fit the gas tank in the bed
high lift mount with gas tank underneath
here are some shots that the BN guy wanted of the mud flap mounts
installed toyota rear leaf springs up front and one leaf from the old leaf pack
installed custom valved fox shocks along with limit straps and relocated bumpstops
installed 10" travel driveshaft
moved the gas tank from under the truck and into the bed , possible 4 link in the future
Slip yoke eliminator
moved everything back to fit the gas tank in the bed
high lift mount with gas tank underneath
here are some shots that the BN guy wanted of the mud flap mounts
Last edited:
penski61
Observer
fishy_frontier
Adventurer
Looking good:victory: I really like the placement of the rock lights.
penski61
Observer
they are just led licence plates lights from autozone
i was using one for my licence plate but got pulled over by a bored dps officer and said the lights were too bright and i got a repair ticket for it
so rather than wasting it i bought 2 more and used them as rock lights lol
i was using one for my licence plate but got pulled over by a bored dps officer and said the lights were too bright and i got a repair ticket for it
so rather than wasting it i bought 2 more and used them as rock lights lol
Last edited:
penski61
Observer
goin with a 9" for the rear so i can better match the front gear plus the yota housing is rusted inside
picked up a full width housing for $32 from a JY
got all the brackets cut off and down to bare tubes
then made a rear brace and skid, reason i made it this way is because im still using leaf springs
then cleaned the axle up better today , plated the bottom of the axle with 1/4" and added a rear skid
picked up a full width housing for $32 from a JY
got all the brackets cut off and down to bare tubes
then made a rear brace and skid, reason i made it this way is because im still using leaf springs
then cleaned the axle up better today , plated the bottom of the axle with 1/4" and added a rear skid