So. Cal.Offroad Fabricator Recommendations to Build Aluminum Flatbed for FWC Hawk

[con kso]

The NorWelds are awesome that's for sure!

 

[FMF]

I had my aluminum flatbed built for our tacoma in Pa for about 3,500. For some reason it's not letting me upload a photo. But if you click the webpage in my signature you will be able to check out photos of it.

 

[CCPAJeeper]

FMF, popped over onto your site, very nice rig. Martin Truck bodies builds a very nice, solid bed for an extremely reasonable price. I used to live near Altoona, PA. have seen many of the beds. Anyone needing a flat bed should consider them for the build.

 

[con kso]

Nice rig - a little bit of a run for me since I'm here in San Diego though. I just pulled the trigger on a flatbed to be built by Marc over at XPCamper - should be sweet with aluminum storage boxes below and above (in front of the camper - I have a longbed and will be putting a 6.5' long Hawk on it so I've got a nice space for a "garage"), pullout rear trundle drawer with flat surface to act as a table, 30 gallon water tank and ARB slide for 50qt fridge. Pretty excited about it.