UJOR Build Thread

[ujoint]

Any suggestions on getting off the radius arm bracket bolts, before I get the plasma to it?

15mm swivel head or a wrench.

 

[CaptainBuilt]

15mm swivel head or a wrench.

I thought the nuts on the inside came off. I guess thy're permanently attached.

I'm an idiot. Should have read instructions. Thanks. Carry on.

Fixed:

Axle going in tomorrow morning:

 

[ujoint]

Ed is on the ground

 

[ujoint]

Teardown

 

[ujoint]

Fresh ink!

 

[CaptainBuilt]

Where was that at?

 

[ujoint]

Where was that at?

Where did I find the magazine? Or where was the photo taken?

 

[CaptainBuilt]

Where did I find the magazine? Or where was the photo taken?

Where did you find the magazine? I was looking at Ingles for it. I'll try B&N today.

 

[ujoint]

Where did you find the magazine? I was looking at Ingles for it. I'll try B&N today.

Yea, B&N.

 

[ujoint]

Ed is mobilized, almost ready to go home!

PA5.4 progress

This weekend may have been the peak for leaf season so we got the RS out for a wrap session. Even saw some snow at the higher elevations!

 

[glennm01]

Has anything happened with that SRW step van you posted a few weeks ago? Very curious to see how that turns out.

 

[ujoint]

Yes we only build vans but get talked into custom jobs every now & then by friends or existing customers. Our buddy Jed needed a rear bumper and rear skid for a water tank & OBA on his custom Tundra camper so we knocked it out. We also did the Camburg coil over lift, custom spec'd rear springs and some plumbing/wiring.

 

[ujoint]

Doug is back for round 2 with UJOR, this time a super nice V10 Chateau!

PA5.4 on the ground!

 

[Matt.H]

Yes we only build vans

E-series short buses still on the menu?

 

[ujoint]

E-series short buses still on the menu?

For sure, any 92 to current E series chassis!