Vuck time!!!!!!!!

[ujoint]

Fun!

 

[B-Excurgin]

Minimal Progress: Frame is painted except for the welding up front. Also...........................



MY Fenders showed up. This is me just goofing off but I think this will look mean. #V4littlebro

 

[partsflyin]

Digging the fenders

Sent from my SM-G930V using Tapatalk

 

[ujoint]

Awesome, I planned for glass on V4 and had them ordered, they never shipped and it turned into a fiasco.

Going to look good!

 

[B-Excurgin]

Awesome, I planned for glass on V4 and had them ordered, they never shipped and it turned into a fiasco.

Going to look good!

Nice I think this just proves Chris we are twins. hahah

 

[B-Excurgin]

So not a Vuck update but still joy. Finally finished studding and deleting mega bus (wife chose the name). Now to drive it make sure things are right then bulletproof His little brother Chester (one of my work vans just spacer lift and 33's). My neighbors think I am nuts hahahah and they haven't even seen the Vuck yet ???.

 

[B-Excurgin]

Little Progress: got the rust hole Patched and rear springs came in. And last but not least my 5spd yay.

Up next rear axle install run brake lines and fuel lines. start with the front Ujoint stuff.

 

[malcolmzilla]

Subbing. Nice skills.

 

[TomsBeast]

Dam! you even put the crumple zone creases in it! Nice!

 

[ujoint]

Crumple zones! Nice patch, god or better than new.

 

[B-Excurgin]

Slow and steady wins the race.............................. But Im dying over here having to work on real work$$$ and just see this thing sitting in my shop. But my bro Ron came into and killed it. Also not shown Got the fuel tank cleaned painted and install.

 

[B-Excurgin]

More from today: we are on wheels again!! Now to put the Engine back in to get the tranny sorted before the body goes back on.

 

[Bikersmurf]

More from today: we are on wheels again!! Now to put the Engine back in to get the tranny sorted before the body goes back on. View attachment 501656

Any plans in the works to beef up the cross-member that has been completely obliterated?

 

[B-Excurgin]

Any plans in the works to beef up the cross-member that has been completely obliterated?

I think it will actually be ok. Im going to let the motor sit in there for a bit then take a look at it. I am going to put the Ujoint front frame support in.

 

[B-Excurgin]

Look what Happened today. Come on fuel lines and brake lines. Also Driveshafts