View attachment 224706
I added seat heater to the rear outside seats. Got a set a TrekArmor seat covers, then suck the waterproof heaters to them, ran the wires under the carpet and wired the switches to the back of the center console.
Would love to have more pics & details on this...
Sorry don't have more pictures, but here is what I did.
I purchased these set heaters
http://www.cobraheat.com/WarmSeats-Waterproof-Seat-Heater-_p_9.html
I got these rear seat covers, but any good seat covers should do the trick
https://www.trekarmor.com
I purchased some really good 3M tape, I think this is it, will try to find it tomorrow and look
http://solutions.3m.com/wps/portal/...-Tape-987?N=5472715+4294864211+5581386&rt=rud
1) I put the tape on the seat heaters and let it sit for a few days
2) cut the heaters to fit the seat covers, you can length, DO NOT CUT WIDTH
3) stuck the heaters to the seat covers
4) put the seat covers on with the heater wires coming out the back of the seats
5) took off the rear cover of the center console, this is done by opening the top part, removing the 4 screws that hold the hinge and lifting the cover off, then pull on the rear cover and it should pop off (2013 model year here)
6) I had to add some wires to the seat heater wires to make it reach the center console.
7) drill the holes where you want them, it says 20mm holes, is about a 13/16, I used a 3/4 and did some fileing to make the switch fit
8) run the wires under the carpet and then find a way to stuff the relays and wire to the sides of the center console, there is room in there for them to fit
9) ran the powers wires to the engine area, I have an spod, so I hooked them up there, that way I can control if they are on or off.
Hope this helps