What did you do to your Mitsubishi today?
- Thread starter Nebel
- Start date
Vanatee, yes it is. I just ordered a different thermocouple and drilled and tapped my adapter pipe to accept that thermo instead of the probe one. They are a great little unit, for a very good price. Couldn't get both a fan controller and a temp gauge for that price anywhere else! Fully adjustable...love it.
I use the same one in my fermentation chamber as well as a meat curing chamber
I use the same one in my fermentation chamber as well as a meat curing chamber
Changed a radius arm,had a gen 3 3.2 on loan a few weeks ago,it had been fully polybushed and it was nothing but rattles and squeaks so I decided I'd get a radius arm out of my shogun that has rubber bushes to stop my pajero feeling like a defender.
Also clipped up my brake pipes properly,bled them, new pads and new shock absorber bushes.
Putting her through the Irish equivalent of the smog next week,so I hope it passes without any drama. It might need an Italian tune up before then as it is turning into a coal roller from being driven easy.
Also had a blown headlight bulb that I was too lazy to replace, my laziness caught up with me when the one on the other side blew in the middle of nowhere!
Also clipped up my brake pipes properly,bled them, new pads and new shock absorber bushes.
Putting her through the Irish equivalent of the smog next week,so I hope it passes without any drama. It might need an Italian tune up before then as it is turning into a coal roller from being driven easy.
Also had a blown headlight bulb that I was too lazy to replace, my laziness caught up with me when the one on the other side blew in the middle of nowhere!
bikerjosh
Explorer
baby steps
Finished wiring my momentary switch for the headlight washers (PO, replaced stock w/one w/o washer button), tapped the wire harness and ran new leads. Relay clicks, now I need to trouble shoot washer pump.
Replaced reverse bulbs with bright LEDs, replaced door courtesy lights with leds, replaced vanity lights with leds.
Hit a snag on overhead lights LEDs appear too big, need to figure a solution.
Finished wiring my momentary switch for the headlight washers (PO, replaced stock w/one w/o washer button), tapped the wire harness and ran new leads. Relay clicks, now I need to trouble shoot washer pump.
Replaced reverse bulbs with bright LEDs, replaced door courtesy lights with leds, replaced vanity lights with leds.
Hit a snag on overhead lights LEDs appear too big, need to figure a solution.
Installed new valve cover seals , spark plug tube seals and plugs and wires. Took about 4 hours . Next time it should only take about 2 . But the next time I open up the valve covers it will be to do my valve guide seals. Can't wait for that. I'm sure that's job will take a couple days .
cnutco
Adventurer
www.superbrightleds.com will have the size you need. I have replaced all in the rear except the turn signals. I am debating on what lights to upgrade next.
Jay Ayala
Explorer
bikerjosh
Explorer
Very cool, bookmarked the link. I'll have to give that a shot. I was surprised that washer pumps for these were about three times more expensive that the generic ones used in my third gen 4runner. Thanks again
jhill15
Explorer
Sweet rig sneakyninja! I only wish it were too sunny where i'm at to be outside. Instead its really cold with absolutely no snow to make it tolerable to even go outside. :jealous: of the rig and the weather lol!
Similar threads
