Search results

I have the largest CVT tent and always use the annex. But it's a pain to assemble and dis-assemble, as I'm sure others know. So, do you leave the floor/tub attached to the walls of the annex when you tear it down? Or do you remove and re-install the floor each time? I've thus far removed the...

Hey Folks, I'm wondering if anyone has a source for the lashing/tie-down points you see in this photo? This is my M1101 and I need to acquire some more of these to rig up a lashing point on my tailgate for some extraction boards. I could use some stuff from HD or whatnot, but I would like to...

I learned something today that I was unaware of, and perhaps I was the last guy to know! For those who may be wondering about the braking system on these trailers (M1101/2) it is what's referred to as a free backing system. I was curious as to why the surge unit did not have a lockout for...

Hey guys. There's a lot of wisdom in all things electrical here, so I figured this would be the place to ask for assistance. I've converted my surge brake rig to an electric over hydraulic setup. The system is working as it should, however, I've got a wiring issue that needs ironing out to...

I'm wondering how others are dealing with the issue of security for expedition type trailers (i.e. the typical rolling storage box with an RTT on top). I've got an M1101 that I am just fine with as an "open box carrier" while enroute to and on trail. If I'm concerned with rain and or things...

I've been searching this forum as well as the web in general and have not found anything directly addressing this question. I have an M1101, and for now I am going to use the trailer as originally equipped, however I am doing research for future upgrades, and brake system is the item I'm...

I'm placing an ArkPak730 (with a 125AH AGM Batt) in a trailer that is connected electrically to the tow vehicle (2008 Tundra with factory installed tow package) via the 7 pin connector. So I have wired the trailer so that the Batt terminal of the 7 pin is connected (via 10 gauge wire) in a...

So I've got a 63 QT ARB on the way and I'm wondering where I should mount it for my camping rig. I've got an M1101 trailer project ongoing (thread in this forum) and will be towing it with a 2008 Tundra. So my question is just how much bouncing and jolting/jarring can these things take...

Does anyone have any insight as to what the cons would be to using an aluminum fuel transfer tank (new of course, never used for fuel) as a water tank. It just so happens that for my application and desires that the best option is to use one of these aluminum tanks vs. anything that I am...

Here's a few pics of the M1101 that I recently acquired. I've decided to keep the hitch, the tires and the brakes stock for now and see how I like them. I can't see getting rid of the tires with the run flat capabilities, as the way I see it this negates the need for a spare. And dropping...