Search results

I am sorry. I can't believe that. That engine does not come in a Toyota that is currently for sale or used in California and that would be the first item that DMV and the referee would use to turn it down. The only way this could be done was if it was on a vehicle that was too old to have to go...

Is there any way you could block the video so people in California can't see it? It is just too damn depressing. Maybe the ultimate perfect swap. I am going to have to unsubscribe to this thread. I just can't take it...

You're right, that 10" is alot. But are you going to use your rear bumper as a tire carrier or anything else? That is the only reason I would go with the Finch. Also, Eagle needs a set of steps and the Finch you can use the bumper. Finch less weight, less weight towards the rear. Eagle more...

Love this light. I put this same light on my Eagle before we went out to Baileys Cabin. As luck has it, there was almost no moon. I love this light, it works perfect! It was windy at night and the light did not pick up flying debris. I installed the LED light bulb from the porch light I...

Very strange. The math is showing that the R&P's are closer to 4:56. But if you like it that is all that matters. 3000 RPM's is a little high for fuel mileage. Jeff

My .02 First, all three builders make a fantastic product. You can't go wrong. All three have very good customer service. Stan from FWC is here all the time. Due to my work, I have set my camper up more as a 4-5 day camper. Nobody on here uses their camper like Kcowyo. Yes, I am jealous. So I...

Yes, I am very interested too. Remember, on this forum, if there are no pics, it didn't happen! Thanks Jeff

Tell us your tricks! Nathan, would you please tell some of us amateurs some of your little secrets? Some of the best off road vids I have ever seen. What cameras? How do you do the smooth rolling shots? What do you edit in? I am just learning, but you are now my idol! Jeff

What year is the cruzer?

But to answer your question, you should never dump your potty in the wilderness. That is what they use to close areas of the Rubicon and other areas. Take it home and dump it or stop at a dump station. Jeff

How about airing down the tires when off road? With a FWC Eagle on a Tacoma and E rated tires, how low can you go? Jeff

Yes, if Gabe is too busy to weld it, I am also in Upland and it would take about 5 minutes to fix it right. Jeff

Good point. I forgot to say how I did it. Take the top channel out altogether. Take sticky backed velcro and run it along the top of the panel. That way you set the access panel with the foam backing into the bottom channel and then push the top into the velcro. I also made this change to the...

Make sure you cut some small pieces of foam and glue them to the back of the access panels to the tie downs. I even put some thin foam seal tape around where the panel seats against the side of the camper. This made a huge difference. I was getting a stream of cold air. Jeff

Mikeeeee, where and when is the first trip? What does Mom think of the camper? Jeff

I don't know if you saw my rig at the Rendezvous, you left early and I was on the other side. This is what I did with my over hang and you have more room. I also added a wind deflector to the front over the cab.

Wait till Mama gets to wake up to a nice warm camper in the AM:wings: and then make coffee while still in her PJ's.:coffeedrink: You are going to love your FWC. Jeff

Very nice Mike! Welcome to the club. Let me know if you have any questions. Keep the door open when you pop it up. Jeff

Mario, do you have any pics of where and how you have the heat exchanger mounted? Thanks. Jeff

Ok, I think we are all confused.:Wow1: Is your truck a 2wd non TRD 4 cylinder and you want to swap in the E locker? If so and you have bigger tires, use the 3.73 that comes with the E locker. Did I get it right? Jeff