Search results

already done the pump rub fix. Encoder just requires pulling the electronic motor and splitting its case

NICE!!!!!!!!!!!!!!!!!!!!! did you trim the rear quarters or just build around them? Always wanted to build a Expedition.... Had a 97 F150 that was the best truck I ever had...….although my 03 suburban is in a close second.

Gasconade????

Its all perception they are all ment to be parked by the soccer mom in the same size parking garages every where. My suburban is not near as big as people act like it is. I had a guy on a recent trip in a 100 series tell me there was no way my suburban would go down the same trail he could...

No skid on mine. I was morr worried it was the encoder on the shift motor. 70 bucks or so. I did fo a quick look at the wires and the appear to be okay. Whats up with the driver window? All 4 of mine are as slow as Christmas.

Really the button..... i was expecting the thing on the shift motor.easy enough.

Drove it for a couple of hours today with no problems. Maybe yesterday I pushed the button on accident i did just get all my teath pulled.

Maybe my tool roll and stuff wont kill me in a roll over now

So i had a weird experience today. I left the Dentist office today when i pulled out in traffic it acted like it went into limp mode. No dummy lights, although I did notice the 4wd button was lit up on low range, i came to a stop sign and went on and it did it again both times I was able to...

I still need to purchase some latches and figure something out for the turnbuckles on the front of the box. The turn buckles I have are too big i cannot tighten down the box with the seat down if I tilt the seats and then tighten them up when I drop the seats back down thy will not latch it...

With two coats of the cheap rustoleum bedliner it tough, but i do not like the texture. I wad hoping that sense this was brush on it wild smooth out but i was wrong. It does hold stuff very wel i have a milk crate eith a bunck of fluids in sitting on top ot slid around more than it does on...

Its easy to be the first on the water when you wake up there. I didn't plan on fishing this morning but i couldn't help but to mess with these little sunfish.

I overnighted at one of my fishing holes yesterday, didn't get my drawers done beforehand but I wish I would have. I slept good once the people running coons left, those dogs are so loud, also people was running around out there i3can only assumed GRD'n (gravel road drinking) . Full moon and...

Got a little more done thes week. I get about three hours a night but its an hour to take out another hour to put up. I need to get my toyots project gone so i csn use my shop again.

Got some holes filled an holes drilled the bracets all bent up for the rear most fasteners. The factory bolts are used. I will install the bracket to the box with some short carriage bolts with fender washers on the inside of the box

A little weight savings, we will see if they say anything about it on my next inspection this month. Im more worried about the boots on my TRE's are busted.

So the nut on to of the sway bar end link didn come loose is a funky type of nut abd it just pulled the hat off the nut the threaded portion is still on the bolt.

Missouri...where I like to fly fish and where I usually fly fish in.

Not done but almost there.

unfortunately like this, but not for long after I get this drawer system done I have something planned, kind of hard to explain. I thought about using hammock straps across the top and just fastening the rod tip and but end into the premade loops. may still go that way.