Search results

I had already noticed this exact detail, I let the engineer know, hand drive the translator did not understand it previously. In Spain the maximum vehicle capacity from the center of the last axle is the attached image of the technical sheet, it is strange that they are more permissive than in...

I forgot to tell you that my chassis has been cut, but the engineer did not do it when it came to overlapping the cell on top.

I forgot the wedge rear section, it provides departure angle, since the box with 4630 external measurement is already very limited.

II have 2 spare wheels, the same system as the one in the photo.

I need to polish the distances a little, this is the first plan, I have to modify the total interior height that I am going to change to 205 and the aerodynamics of the front hump.

Well, the engineer for the final touches, the plans and the design is our copy of www.azimoo.com since we carry a ceiling bed with actuators

I don't know exactly the distance but the panels are 6.5cm and thermally they are very good, on the outside I have a honeycomb panel that gives more consistency, (in principle I think the gap is enough but I will tell the person in charge) it is a company with a long history and a lot of...

Good morning guys. I present to you my Cell. I am going to lower my height by 5 centimeters. My colleagues advise me to lower my height as much as possible.

Thank you very much guys, I think it helps me. Greetings.

sorry I use a translator I would like to know the system that ATW or Offroad uses for their opening Pull bars to be able to tilt the cabin, since I am going to build one Regards

Good friends some video of the system that Fusooffroad or ATW uses for their Bull bars. greetings

What cell width and cell height do you have?

My opinion is that you use the system you are going to use, make it all in one, for example if you use Imas gas or if you are going to do it with Webasto you can have the option with a boiler or with heat exchanger plates, but one hot water for all. Agua caliente y calefacción mediante sistema...

We practically have the same measurements, well I have a tad more 4500 internals. The aerodynamic issue of the cell is quite complicated. I have opted for the Polish system. https://azimooexpedition.com/en/en-azimoo-tepui/ that little front hump The only drawback is that you should not put too...

an image of the Fuso chassis and subframe.

this one is mine

look for bellows for articulated vehicles

I understand that the Fuso axis is not hollow?

Any partner with an adjustable self-inflating system, I know this one from https://eurocolven.com/products/vigia-nm344 but I would like more inside the axis

How is it working for you cruise comfort? can you say what it cost you?