Search results

^^^ This(y)(y)(y)

I use mine on a Gas one single butane/propane unit. Yes the bottom is flat

Ahh now I think I know what the problem is. Can you modify by trimming lip upward an doing a barn door approach or fab a bigger flip up? With all yu have done already this type of issue is rather small?

I know it may sound dumb but have you considered a spacer of some material on top of your bed rails to raise the shell up? I'm guessing here because I really don't know how much room you need 1or 2"? Where that could get sticky is the rear window to tailgate fit.

Where there is a will there is a way my friend, to bad the slide can't be recessed into the ply just a little or is the conflict to large? If it was simple everyone would do it. LOL

You could've fooled me, I stand corrected, thank you sir.

Rust on a cast iron cooking utensil? Whatever happened with seasoning?

The fuel/air mixture is off, you need more air.

Drill holes certainly hasn't stopped you up till now? lol

Nooooo!! If this fails you will be replacing a lot more than you hope for.

Mine just arrived, soon as rain quits I'm firing that puppy up!!

Sierras

Those notches really help keep the bottom of the tank from skating out away from the bracket

Location please?

I just ordered a couple, looks like it will work well with my new butane Gas 1 setup.

I think if you fab a bracket the strap needs to be metal per DOT regs.

Make sure you have the low voltage cut out set at the level you're comfortable with.

I've done baked potatoes, pork tenderloins (actually just about any cut of meat), warmed frozen entrees like frozen shrimp fried rice (I added about an ounce of water to promote steaming action). I would be hesitant to try real wattery stuff if you were rock crawling lol. Chili would be doable...