ball joint (and tie rod ) taper

['round n' back again]

does anyone know from recollection the taper of the mitsu ball joint? 4 degrees?
same with tie rod. the idea fermenting in my noggin is to go with some serious surgery on montee and use a non mitsu UCA. possible rack and pinion, if i get ambitious.

any one have these answers?
i suppose it might be in the napa book, but getting the book out is too much work for the help there.

 

[ChrisCosta416]

Total Chaos has uniball upper control arms for the Gen3

I also have a set of custom clearanced upper control arms for the Gen3

 

[Toasty]

At that point you might as well swap a complete Gen 3 IFS subframe under the Gen 1.