PlethoraOfGuns
Adventurer
We've been cruising pretty good. This rig gets us lots of places!
Rig made it to 10000'. It was a long, slow haul in 4th gear, but she made it. And never overheated. I call that a success!
But on the other side of the pass, in the desert, we started smelling diesel fuel. Sure enough, we ruptured a return line. What a mess...
Just a little 3" piece of hose, ugh. I figured it was just old hose.
So I replaced it with some cheap vinyl hose I had laying around, hoping it could get me to a store to find the right hose. But it immediately exploded. This is a return line to the fuel tank, how can there be that much pressure?
Some digging found the culprit. When we did the clutch and reinstalled the transmission not too long ago, we must have pinched the return line with the transmission bracket. Luckily, the only damage that was done was a blown line!
No point in removing all that transmission stuff, the pitched hose is probably shot, I wouldn't trust it after being pinched for so long, so I just cut out the bad section and used a barbed coupling I had laying in the toolbox. A section of this hose was cut and used to fix the original 3" section of blown hose. Back on the road!
Rig made it to 10000'. It was a long, slow haul in 4th gear, but she made it. And never overheated. I call that a success!
But on the other side of the pass, in the desert, we started smelling diesel fuel. Sure enough, we ruptured a return line. What a mess...
Just a little 3" piece of hose, ugh. I figured it was just old hose.
So I replaced it with some cheap vinyl hose I had laying around, hoping it could get me to a store to find the right hose. But it immediately exploded. This is a return line to the fuel tank, how can there be that much pressure?
Some digging found the culprit. When we did the clutch and reinstalled the transmission not too long ago, we must have pinched the return line with the transmission bracket. Luckily, the only damage that was done was a blown line!
No point in removing all that transmission stuff, the pitched hose is probably shot, I wouldn't trust it after being pinched for so long, so I just cut out the bad section and used a barbed coupling I had laying in the toolbox. A section of this hose was cut and used to fix the original 3" section of blown hose. Back on the road!
Last edited: