F/S Huge Hand Tool Lot mostly Craftsman.

Why, oh why, do I not have a garage? I have both the money, and am not too far to pick this up. But, I have less than no room to store these tools. Argh!
 
I'm not oppossed to shipping these, if you are on the west coast probably would have $200ish into shipping, on the east coast probably $300ish, using UPS or Fedex and boxes loaded to about 50lbs. Also: kitchens, living rooms, and bedroom closets are all fine places to store your tools - you can just tell everyone to maintain proper metallurgical strength they are required to be located in a climate controlled environment! - They'll understand, I'm sure they will ;)
 
Well crap, I'd love to get them and the stainless tool boxes off your hands, but I am too far. Great deal though for someone local.
 
Are you willing to sell seperate pieces? I have been looking for a stubby wrench set and crows foot set.
 
Not looking to part out at the moment, prefer to just sell the lot as is. Also if your reasonable close within a state or two I might be able to put delivery together for the cost of fuel and a room etc. Have a crew cab long box duramax for delivery.
 
Seth Kendall said:
Why, oh why, do I not have a garage? I have both the money, and am not too far to pick this up. But, I have less than no room to store these tools. Argh!

Put them in a couple boxes, throw a sheet over them and call them an end table!
 
The gray box with the deep impact set is a generic brand. The impact sockets you see on the table attached to socket rails would all be craftsman.
 

Forum statistics

Threads
191,010
Messages
2,931,578
Members
234,901
Latest member
LukeSkywalker515
Top