Whatever was stock on the bts system? Anyone know if the eibach springs used on the Toytec system the same? They are 650lbs
Lhanson 1st Gen Tundra Build
- Thread starter lhanson
- Start date
Whatever was stock on the bts system? Anyone know if the eibach springs used on the Toytec system the same? They are 650lbs
How much trimming did you do too the pinch welds? Any photos or recommendations? I am hitting the top of the fenders as well. Maybe the Toyo At2s are extra big P285???
I just got Eibach 2.5in x 14in 650lbs coils. It should lift my bts coil overs back to full lift.
Sorry for the delay but I have finally gotten my tundra build underway. School as been bringing the hammer down. Here are the updates:
Installed Ebiach 650lbs coils aligned truck and folded pinch weld over->
Installed All Pro Sliders (Powder coated satin black, 3m grip tape on top and bolted them on)->
Installed Baja Designs OnX6 20in with mode selection (Current plans to mount all switches for my Baja Design lights under my stereo like so)->
After a trip off roading in big bear I preformed basic maintenance (fuel filter change, oil/filter, and air filter). Debating on a drop in Dry filter or Cold air intake with a dry filter such as AFE. Suggestions and 2cents?
Next on list:
Mount CB radio and 2 foot firestik antenna on bed by cab and mount highlift jack on bed as well
On board air. Thinking Arb Twin as I will be getting a rear locker in future most likely. All open diffs is wild.
Baja Designs XL x 2 for bumper (cornering lights) and 2 sII for bumpers and possibly rock lights
Roof top tent from Tepui hopefully soon on top of thule contractor rack
Installed Ebiach 650lbs coils aligned truck and folded pinch weld over->
Installed All Pro Sliders (Powder coated satin black, 3m grip tape on top and bolted them on)->
Installed Baja Designs OnX6 20in with mode selection (Current plans to mount all switches for my Baja Design lights under my stereo like so)->
After a trip off roading in big bear I preformed basic maintenance (fuel filter change, oil/filter, and air filter). Debating on a drop in Dry filter or Cold air intake with a dry filter such as AFE. Suggestions and 2cents?
Next on list:
Mount CB radio and 2 foot firestik antenna on bed by cab and mount highlift jack on bed as well
On board air. Thinking Arb Twin as I will be getting a rear locker in future most likely. All open diffs is wild.
Baja Designs XL x 2 for bumper (cornering lights) and 2 sII for bumpers and possibly rock lights
Roof top tent from Tepui hopefully soon on top of thule contractor rack
Last edited:
seanpistol
Explorer
Looks good!
Sorry for the late response, but I completely ground down my pinch weld. Photos in my build thread.
Sorry for the late response, but I completely ground down my pinch weld. Photos in my build thread.
Yea I think I need a few more. I can't put my finger on who can help but I'm sure you can help me out 😎
I'll post some pictures after this weekend. They use self tapping bolts. Drilled 31holes haha
seanpistol
Explorer
If you got the tools make one yourself! If you don't- get a fab shop to do it. They're basic so it shouldn't cost too much. Brute Force Fab makes one, but it has bo benefit for your departure angle.
I have a shop I use for custom fabrication religiously and Im most likely going to have them build one. I just want to see if there is any out there already being built. Some days I wish I had a 2005+ tacoma. So many options out there for parts.
