Recent content by revor

So Pretty!

Say it isn't so Kevin!!! I have to say that I too have experienced life changes that are making new decisions for me... Going from Red to Blue will be tough but a good choice in the end..

New Camping rig! Howdy folks. While I'm not new here (I used to live over on the Rover forum) I used to be a Slide in camper guy years ago due to the simplicity durability and comfort!!! Over the years we did more "expeditioning" Using Roof top tents and a sweet little trailer with a RTT...

There's a clean D1 at Land Rover Roaring fork with a blown motor. Probably have it for a couple hundred bucks.

I have thins symbol in my wiring diagram, I don't know what it means....

UJ's travel in a elliptical rotation when they are not running straight. In a single cardon type shaft (only two UJ's) the angles between the two joints must remain within 5 degrees, otherwise the ellipse at the front joint is different enough from the ellipse at the rear joint to cause vibes...

Every single day I drive my Defender (s) Wouldn't have it any other way. The 90 is a hoot and the 110 is an RV, our "fancy" car is a mildly modded D1... For errands and around town a 90 is hard to beat! I'd at least look to get a 200Tdi though.

It's basically a stripped version of a standard disco with cloth seats and yellow paint.. Nothing special in the driveline the only cool part aside from being pretty rare is there are no holes in the roof aside from the alpine windows. Oh and they have a front skid plate (I have one for sale) If...

And Camel trophy trucks are sandglow

Looks like one of those situations where the guys riding in the back question what the heck the driver has gotten into now....

I'd do that!

I'm of the opinion that you will benefit more by swapping the diff gears. While the 1.4 high range will give you the same (similar enough) final drive ratio as 4.1's in high range the final drive in low range is no lower. If you swap the gears and maintain the 1.2 high range the final drive in...

To the missing zerk thing. I run 1310 joints in all my trucks. That's given me the opportunity to try an experiment using sealed joints. One truck has sealed the other greasable. I hate to say it but it's 1 to 0 in favor of the sealed. I'll be honest the sealed are in Karen's Disco but she...

Oh the list I have....... I need a couple clutches HD versions! A TD5 manual tranny, a pas pump for a 300 X2. A water pump for the same... However if you run across a reasonably priced full width intercooler for a 300 I'd be thrilled!:sombrero: Most her know I'm good for it.:victory:

Don't forget extra accelerant!