Search results

just keep a eye on the side wall. at lower pressures it may contact or if there develops a slight bulge in the side wall it will hit. also keep a eye on the springs pack and make sure it don't twist.

The one i have is a m416 that the army reserves molested bad. All the sides where cut off, it now looks like a generator trailer. The flat bed trailers JeepDreamer is talking about is the generator trailer. Its the same frame wheels fenders and all just don't have a tub on it. The good thing...

i have ran them on both a 7" wide wheel and a 8" wide wheel. If you want to run them on a 7" wheel you have to run lower pressure so the top of the tire don't crown and you don't wear out center of the tire. With a 33" tire on a 15" rim you have enough side wall not to put to much pressure on...

my only thing i dont like about them is the stick so far off the back. i have killed my lower rear 1/4's and rear bumper. goin to kill a departure angles. but if your not goin to run into bad departure angles then it shouldnt be a problem.

the paint is all fadded on my hood so i dont have a prob at all. my lights are mounted on my hood.

pm sent

let me work on something over the next few days and ill post something up.

Hey man I'm a XJ nut and a fabricator I can make you some. Pm me and we can work out the details. I can make them bolt on for you. I mounted mine on the hood though.

hey dave do you have a build thread on your GC? i want to see how you did the cut on the back. im gettin ready to do somehtin sim on mine and wantin to do a hmmwv slant back style.

you can get them with brakes. i bet the spacers would work.

you could also use conversion spacers if they offer them in that configuration.

I lean towards what Moose said. I have recently had 2 friends both doin close to the same thing. Both of theirs where fuel pump problems.

i noticed on one forum where a guy just swapped the axle out to one that used the same lug pattern as his yota

I plan on it. I wasnt sure how long I needed when i cut the tube. I knew when i made it i could always cut it down if i made it long. If made to short then i would be screwed. The reason the plate is so big on the pintle is I dont have my plasma cutter wired up yet and the pintle came welded to...

The back of the Cherokee is saggin a bit cause there is about 500lbs to 1000lbs or more of cargo in it. Also im bout to lift the back another inch and also stretch the wheel base in the rear a inch or so.

I got a mil M46 trailer the other day to build into a expedition trailer. Someone cut the sides off and raised the fenders to clear HMMVW tires that was on it when the mil pulled it carrying a generator. I'm goin to build new sides for it, build a hinged top, put a roof top tent on it, carry a...

I was debating on puttin the mil plug on my Cherokee. This is the only trailer I'll pull with it, and wont have to have the conversion plug for lights to work.

well either way you go you now have a diagram to go off of

i prob wont ever use the stock ones either. need a set?

I only gave $50 for it anyways so either way it was well worth the buy. I just have to fab the tub now unless i can get "them" to get me a tub.