Search results

if you do want to put a pass through, you could sill keep the L-shaped dinette, just have the part of the bench that goes infront of the pass through hinged to move out tof the way. you would have to remove the water tank, but you could get two smaller ones to go in the parts on either side of...

ahh its nice to see another 2nd gen 4runner. well mine is a grey import surf, so the body and frame are the same, its got a 2.4 turbo diesel in it, and much like a 22re its fairly underpowered in northamerican highways, but in the dirt it pulls nicely. put a 1.5" bj spacer in the front and a 2"...

the bracing isn't in place, you have to buy them from toyota and install it yourself. the tire carrier itself can be found on second generation 4runners.

be carefull of those jap imports, I own a 92 surf, with a 2.4 turbo diesel. I had the head crack from front to back on mine. the truck was down for a couple weeks and cost me $3000. I didn't go with the usual replacement head though, I got mine from a place called Allhead in australia, the use a...

I have a surf, it uses the 8" rearend with crush sleeves, i've had 2 crush beyond usable while being used in the truck. the first time was on the factory build, second time was on my rebuild. I'll be going to the solid sleeve and shims to avoid this happening while out in the bush. when the...

I'm also going to throw my vote in for the truetracs. being gear driven rather than a clutch type there is very little maintenance to it. and like ntsqd said, you can use your brake to "load" it and it will keep you moving forward. if your not going to go selectable locker, truetracs are the way...

he's right, two different set ups. on the 4x the torsion bar is on the upper a-arm and mounted above the frame rails, on the 2wd its on the lower a-arm and mounted below. cheapest way would be to keep an eye out for someone selling some upper control arms. i found a set of 2 or 3 inch uppers on...

good to hear it works good.

i know this is pretty old, but when I strip my truck down later this year I had planned on picking up a roll of ice and water shield, a membrane designed for roofing to prevent water and ice buildup on the outer 3 feet of the roof. its a rubber ashphalt adhsive material that comes in a roll 3...

I hadn't even thought about curling, I might have to add one or two, hahaha. the blades are on there as vortex generators not really, we had them left over from the roof rack and didn't want to just throw them out, so they ended up on the trunk

hello everyone, name is Guy I've been lurking around here for a bit and recently started a buildup/rebuild of my 92 xtra cab 2x4. i picked up a cheap 83 parts truck for the drivetrain to swap over. as of right now I have got the parts truck running, and need to make a front drive shaft so I can...