Search results

As long as the axle ratios are same between both trucks...........

Nothing in North America. Don't know about elsewhere. Common axle is the H233B with 4.63 gears. But the only locker that I know of is the ARB for either 31 spline or the 33 spline axles.

You got the American version. Probably a M416 http://www.g503.com/forums/viewforum.php?f=18&sid=4803e484bfd4f4fe4363e486ebfa1573

I've ran BFG AT's for last 20 years and thought they were pretty good in winter too. And in fresh snow they do well. That was until we switched to Yokohama geolandar IT-GO72 winter tire. In hardpack and ice they are much better than BFG's, like going from muds to AT on ice. Better traction...

Just brought her home tonight. Standard poodle.

Use a strap wrench to open and close the MFC. Tighten as much as possible by hand and then give it a little more with a strap wrench.

The spout didn't come with a pouch?

Yes sir, I still drag it around. Have the Engel 60 mounted in the back, battery on the tongue and lots of junk in between:victory:

If you have a trailer hitch you're prety much llimited to stock size or about 1/2" taller

Also have the new MT's but have not hydroplaned. Had them in 1-2" inches of water at about 40 mph. Perhaps it's the short wheelbase combined with wide tire on your truck?

You can buy it already UV treated. Weight wise it's about same as 1/4" plywood, maybe a little heavier

Consider using puckboard. 1/4" thick, lightweight, easy to cut, hard to break, 4'x8' sheets in variety of colours

Nice, I remember picking mine up in 03 North of Edmonchuk.

Lee Valley has them, http://www.leevalley.com/en/garden/page.aspx?p=65248&cat=2,2120,33277

One more for Cobra 75 and a K40:wings:

The lunette won't fit the M101CDN, It's just too big:Wow1:

Picked this up at the store. Not sure if it fits my M101CDN yet. Will try tomorrow. The offset seems to be about 1 3/4 to 2" The dimensions are as follows: Fat end diameter 51.7mm / 2.033" Narrow end diameter 33.1mm / 1.3" Length of flat portion 150.8mm / 5.918" Diameter of threaded portion...

Just saw lunettes with a bend in them at a local Princess Auto store. Threaded on the end. Send me a PM if you want some measurements.

No, gotta do real work. There's no time to take off and go to Edmonton. I will be at the show in Calgary in June though

I still have the XL's on it. While I do want to replace them, they look just too darn good. Plus I have a NOS spare wheel and tire of same kind. Don't want to get rid of them either.:smiley_drive: