Search results

The swap gives you more room on either side of the engine, but is taller and longer. How are you going to tie the top of the header panel together?

My 6.0L was happiest when it revved; they don't have the bottom end torque curve like other diesel engines which like to lug.

Looking good. If you think you might want to regear to 4.10s and install ARB lockers, I do have my 04 for sale. Just a short trip across the border. And it's Canadian pesos. Also has a few other goodies on it which would transfer over.

I pity da foo!!!

That looks like a weather seal for an electric connector.

I think this fits the full size category. :D

The X looks great. My peeve with many of the conversions I've seen is they neglect the rear fenders.

Thanks, I prefer the grill and bumper of the 1999-2004, the headlights of the 2005-07 Harley Edition, and the hood fender of this 2011-16 version.

Just south of Whistler in the Callaghan area.

Weather sucked so instead of going for a ride I went for a drive.

Police are cracking down on LED bars here because too many jack donkeys are not dimming them for oncoming traffic. I reused my PIAA 520s instead of getting an LED bar. Both sets are relayed with my high beams so when I kill the brights, they turn off too. Out regulations say that a vehicle can...

Read this from back to front to return to stock. http://www.remcodsc.com/pdf/REMCO_DSC_Instructional_Booklet.pdf :D:********:

The handle/knob is missing. Pull on the end of the threaded rod and see what it does.

I think you need to go all the way back to 'The Flintstones' era to find a vehicle that doesn't produce emissions. Foot power.

I'd make a 10' tall roll-up door, with 13' ceiling height. Prepare the concrete floor adequately and get a 2 post lift .

Fantastic.

Roof mounted light bars are nice, until you actually use them. You will have so much glare bouncing off the underside of the camper. Speaking of... what happens when you start flexing the suspension? The Ford's C-channel frame flexes quite a bit. Coilovers will reduce the amount of compression...

If you need a source for OEM radius arms, you should contact Trendsetters in Portland. Usually they will scrap them if they install the OUO Adjustable Link Arms. I gave mine to a local to me auto repair shop in case they could use them. If someone thinks they could use them, I can get them back...

I see the pictures now. Sometimes it can be which web browser you use. Van looks good.

It's been 2 days since you got the hard part done.... van finished yet?