Search results

Day 4

Day 4 everyone else packed up and went home and it was a trail day for me and my boy...we got into some pretty good trails

I ended up taking a guided tour with thr rendezvous in the Ozarks staff and was disappointed and the door prizes was great but I didn't get any thing... they gave away rrt, awnings, winches, lights, traction boards alot of traction boards....

Stopped by Oark Cafe. You're not a overlander unless you stop at Oark and get pie.

Day 2 ended up being a trail day.

It was a spark off a flap disk. My eye is still blurry but I can look through my rifle scope and its clear.

The #rendezvousintheozarks was great over 650 rigs showed up. I ran a bunch of trails with #smsoverland it was a great long weekend. I ran the suburban through stuff I probably shouldn't have been on. The Ozarks get terribly muddy but we are in a dry spell well we was the night before I left it...

So being down from my eye I lost about a weeks worth of work and again the sliders didn't get done. I would really like to replace the rockers before welding on the sliders but that is going to require paint and if I'm going to paint the rockers I need to paint the whole lower portion of the...

Got alot done in the time I got back from the black hills to the time I had to leave for the ozarks on an overland. Skids done.

way too much under brush in the bottoms for long shots in the woods around here...I was just up in SD and I could see 100yd in the woods there.

Cutting out more skids

Fish plated the d-ring mounts and got mr rear recovery point done. Let that sucker cool slowly by dousing in aand and letting it sit.

Yes the welds are rough, I'm using my 110 flux core welder on 5/8" thick stuff, first weld slow by turnind down the wire speed. Preheating helps a ton, purposely leave a gap to fill further slowing down the speed. I was able to heat the 5/8 while welding to the point the opposite side was...

Alot done today, replaced a loose idler arm, this one was twice ss thick and way more beefy same part# as before. Changed oil and filter, cardboard aided design the front diff skid, got the bumper supporta welded on ( only problem I will have to cut them off to remove the bumper), welded on one...

Skids on

After a week my vision is still 20/40 when it's been 20/20 my whole life...

Southeast missouri. I will be going down to the rendezvous next month for the first time. I go to the moutian grove area quite a bit. I'm also part of the show me state overland group on Facebook if you haven't heard about them.

My bumper build just got more expensive, embedded in my pupil