Clancy '97 D1 Build
- Thread starter Trail-Tailor
- Start date
Trail-Tailor
Observer
Sent PMs to both of you.
Ok guys,
Here is what the rundown on the sliders.
3" x 2" x .188" rectangle tube
3/16" full wrap sill plates (laser cut for finish quality and accuracy)
Grade 8 hardware. (stainless hardware available for an additional cost)
Sliders (D1 & D2) will be 425$ a set bare metal with hardware (as long as my laser quote stays the same, might go up 15-20$ once final cutting is complete). Shipping is looking to be around 80$ Fed Ex ground for a scattered zip code search I've done.
It should be 2-3 week turnaround they said on them. I'll post a status update once they send me an order completion confirmation to give everyone a better idea on lead time.
Thanks for the interest.
Jason
Last edited:
Rovertrader
Supporting Sponsor
For me, the opposite actually, mitered upward for clearance as we discussed earlier. I realize it will change the lower contact point with the quarter panel, but I can/will trim to fit. Keep what is drawn, but go level or slightly uphill toward the quarter from the high point. I hate my lack of computer skills at times like this- so sorry!! The FJ above is spot on!!
Trail-Tailor
Observer
I'm not dead, just slammed, which is a good thing!
J
J
Trail-Tailor
Observer
Been slammed with orders and not much time for building.
Started on another rack for a customer.
J
Started on another rack for a customer.
J
Trail-Tailor
Observer
Trail-Tailor
Observer
Finish and shipped
Scrapdaddy
Adventurer
Man, here I am trolling around looking at Land Rovers and I run into my favorite fabricator. These guys are in for a treat if they don't know the quality and fresh imagination that you put into your products. I would, but you should put some links up to your MUD threads and let them see first hand at what you do. Now what can you do for my Wife's Focus. 
Keep at it, I'm learning as you go!
Keep at it, I'm learning as you go!
Trail-Tailor
Observer
Man, here I am trolling around looking at Land Rovers and I run into my favorite fabricator. These guys are in for a treat if they don't know the quality and fresh imagination that you put into your products. I would, but you should put some links up to your MUD threads and let them see first hand at what you do. Now what can you do for my Wife's Focus.
Keep at it, I'm learning as you go!
Great to see you diversifying your PORN SEEKING Ron... HEE HEE. Thanks for the compliment on my work. Good idea on MUD threads.
How about a custom grill guard.... HA!
Jason
Last edited:
Trail-Tailor
Observer
As Scrapdaddy said... Here are some of my IH8MUD links for work I've done for the Land Cruiser community.
http://forum.ih8mud.com/threads/custom-bumpers-for-sale.812458/
http://forum.ih8mud.com/threads/roof-racks-and-mounts.873862/
http://forum.ih8mud.com/threads/sliders.903552/
Jason
http://forum.ih8mud.com/threads/custom-bumpers-for-sale.812458/
http://forum.ih8mud.com/threads/roof-racks-and-mounts.873862/
http://forum.ih8mud.com/threads/sliders.903552/
Jason
Scrapdaddy
Adventurer
Thanks Jason, she's going to love that! Actually, it wouldn't be a bad idea out here in deer country.