Cable broke so something in the clutch is messed up. Very hard pedal, return spring is not strong enough to pull pedal back. I have inspected the cable and it is not binding up inside of the casing. I'm wondering if it's the throw out bearing binding on the out put shaft. b-4 the cable broke it shifted, inspite of the hard pedal, thru all of the gears. no slipping on hard acceleration.
Any advice on how to remove the transmission. Took out the starter and the plumbing in the way, took out the dip stick tube. cross member is out, trans is supported with a jack. A couple of the bolts are out, but there are the ones
on top of the bell housing that I cannot figure out . I've cut an access hole
in the tranny hump that gets to one bolt.
Do I need to consider pulling the engine and trans as a unit then seperate to get to the clutch???
Thanks
James
Any advice on how to remove the transmission. Took out the starter and the plumbing in the way, took out the dip stick tube. cross member is out, trans is supported with a jack. A couple of the bolts are out, but there are the ones
on top of the bell housing that I cannot figure out . I've cut an access hole
in the tranny hump that gets to one bolt.
Do I need to consider pulling the engine and trans as a unit then seperate to get to the clutch???
Thanks
James