What did you do to your Mitsubishi today?

[kevinreeves116]

Got my 32x11.5r15 Mastercrafts and 15x8s on the other day

 

[KyleT]

shiny, i need to replace mine too. where did you get it from, dealership?

No but it's the same part. Just an alternator shop we've been using a lot over the years.


Sent from my iPhone using Tapatalk

 

[bikerjosh]

Started replacing my driver side CV joint/axle. Went well until I needed three hands to get the steering knuckle/hub/brake disk back bolted up. Waiting for my buddy to come over. :sombrero:

 

[billygoats]

Started replacing my driver side CV joint/axle. Went well until I needed three hands to get the steering knuckle/hub/brake disk back bolted up. Waiting for my buddy to come over. :sombrero:

Use a jack under the a arm to line it all up!

Edited. Autocorrect screwed up

 

[Marutuk]

Got my car a snorkel

 

[Toasty]

Installed the locker pump in the '82 Mighty Max this morning.

 

[DSouth]

Fixed the fuel tank sending unit, so I finally have a reliable fuel guage.

 

[nckwltn]

Mocked up my DIY roof rack.

https://goo.gl/photos/Yta62RJTw1akQ7WQ6
https://goo.gl/photos/VuiaAfQCF9Ev5rXMA

 

[cap510]

started my half door project.

 

[raysobi]

Got my snorkel installed and spray painted my grill.

 

[Porvalsh]

Did some cleaning. Applied RainX to the windshield, polished the hood a bit to work on some of the scratches. I also got some leather stuff onto the seats.

Hood looks good in the shade, lol.

 

[kevinreeves116]

Got rid of my paint

 

[Porvalsh]

Did headlights...I didn't really need them done but thought I'd give it a try and see if it helped. Not sure it did...


Before After Pics



Looks good until you turn the lights on






Also replaced radiator cap. The system was sucking my hoses in rather than breathing.

 

[cacattack]

Full timing belt service on my 2005 Gen 3

Replacing timing belt, water pump, idle bearing, tensioner bearing, tensioner, thermostat and oil pressure sensor on my 2005 Gen 3 with 97k miles.

 

[JBThompson]

Finished replacing the brake system's hardlines, and replaced the rear pads and rotors. Started doing the fronts but I'm going to need tools I don't have here so those are waiting until later this week when I can get her up on my lift at work.