What did you do to your Mitsubishi today?

[MummifiedCircuitry]

I installed my snorkel, it was a whole day event. I did a ton of measuring, drilling, filing and hammering though, took me about 8 hours.:Wow1:

http://

 

[Jay Ayala]

I installed my snorkel, it was a whole day event. I did a ton of measuring, drilling, filing and hammering though, took me about 8 hours.:Wow1:

http://

Hey Johnny No. 5,
what happened to your bumper?

 

[MummifiedCircuitry]

Hey Johnny No. 5,
what happened to your bumper?

It was dented and bent, chopped the brush guard off of it and mounted it to the frame rails. I can't find an ARB bumper anywhere, so it stays this way.

 

[Toasty]

Put a bumper on the pickup this morning!

 

[bikerjosh]

Installed skid plates and replaced broken grill

Bolted up the new skids and replaced the cracked broken plastic grill with a piece of expanded metal.

Also noticed the majority of my driver side inboard CV boot is gone. Whoops, looks like it is tie for a new axle, probably been like that for a while.

 

[lordtrunks]

pulled leaking injection pump installed new front seal, it was too late in the day to grab the gaskets i need for the side cover plates from perkins so in the morning i'll stop over there for them, fingers crossed they will have them in stock.

 

[JBThompson]

Used the Montero to rescue my buddy's Rubicon after it puked up one of the U-joints from the rear driveshaft.

 

[Jay Ayala]

I fixed a mud flap that was dangling by one screw.

1989 Dodge Raider 3.0L

 

[Porvalsh]

Pulled the air blower to see if I could figure out what the little tick tick tick sound from it was. Cleaned out air box, couldn't seem to find any debris. Hooked up blower outside of its mounting location and it sounds the same. Going to see about getting a new blower. Its annoying me.

 

[BOPOH]

pulled my friend out of a puddle and after that i got something short circuited, every time i hit brakes or switch an electrical component i get flicker

 

[brad2274]

Pulled the air blower to see if I could figure out what the little tick tick tick sound from it was. Cleaned out air box, couldn't seem to find any debris. Hooked up blower outside of its mounting location and it sounds the same. Going to see about getting a new blower. Its annoying me.

I have the same issue, has like whirrr noise almost a buzzing, sounds like a window mount Ac unit its so annoying

 

[KyleT]

2nd try, seems to work out of the box at least.

Sent from my iPhone using Tapatalk

 

[BOPOH]

shiny, i need to replace mine too. where did you get it from, dealership?

 

[Sabre]

Yesterday I finished painting the skid plate I built for protecting the transmission. Steel frame members with aluminum plate skid.

 

[brad2274]

Picked up a garvin wilderness rack for 375, was made for a land rover so i might cut the brackets down a few inches. Its 4.5'x7'x6"