You are the only one talking about removing any skin.
If you are too ignorant to realize how such a simple bolt-thru assembly can be fastened without removing skin, I cannot help you.
BTW, this was 2 weeks ago.... And a few days after this we had near 50mph cross winds that rolled multiple...
Moving to an 18" wheel will provide a much better selection, as you have found.
It is the entire reason we did exactly that, pushing from the factory 17's to a solid set of 18's
It also provides the option for the high payload (4080lb) sizes, though it doesn't sound like you need such a tire as...
Done right, it doesnt take huge hardware to work and survive.
Our camper is mounted (and designed to dismount) using receivers integrated into the flatbed rail.
The camper side is a self aligning assembly that is bonded/glued and thru-bolted to the camper floor, with a few bolts that also thru...
We just finished up a 19 day 4500 mile trip to Texas (primarily for the 2024 total eclipse)
Both the truck and camper took some hits, nothing major.
And everything performed as intended/designed.
These trips always show what changes/upgrades we can make, and this one is no exception.
I have a...
The Toyo AT2 and new AT3 should certainly be added to the list. We currently have 35k on our set of AT2s and if we didnt live in snow country, we would likely get another 25k out of this set. Instead, we will likely swap them
out in another 8-10k. Absolutely incredible to me given what they...
Tough to say the markup is justified, but comparing a traditional TC to a flatbed TC, the space and comfort alone is worth the consideration. Built properly, the COG is lower and balance L-R and front-rear can be managed better.
Ours, well beyond the 10-year mark of being built, is proof...
When you hit northern NV during a whiteout, 200%+ precip spring and misjudge a turnout. 1-2” of crust with bottomless soup underneath. A. moment after coming to a stop we sunk to the axles.
After failing self recovery efforts, we called for assistance. Spent the night, had some local help...
Ive had quite a few request interior shots of our camper.
We are prepping for our next trip currently, and the camper received a deep clean.
Figured it was as good a time as ever for some photos.
Besides the two back cushions that the wife (finally) finished, hey, wats a 10-year delay...
Trust has a whole lot to do with it. And I'm one that has serious trust issues.
Combine that with being a bit old-school, I'm surprised an incident like this hasn't surfaced sooner.
Kinetic pulls in so many ways make my hair stand on end.
Hopefully this reels in a lot of folks that carry...
Also keep in mind that you may want to park the opposite direction, if it isnt a pull-thru site.
The few times that we use a campground, Im typically backed in, to isolate us just that much more from any passer-by.
We operate almost exclusively in the PNW, and a bunch in winter, so some sort of traction aids like chains is not only required by law at times, but a good fall back when actually needed.
We weigh near 12k lbs. While Id love to think a smaller winch than what have might save a good deal of...
The one compartment in our camper that is sealed but not insulated from the interior is the propane tank compartment.
This sheds some heat from the interior into the compartment. Not a whole lot, but when you are talking about -20 degree outside temps, 5 degrees makes a difference.
As others...
Perhaps. Thats why the discussion.
As far as removal, part of the interest in loosing some weight is to make room for more weight :ROFLMAO:
Currently we do not haul the camper jacks with us. Full timing, Id love to.
Removing the camper for a few weeks at a time would be great, for a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.