Search results

I'll take it. Do you take PayPal? PM me with your info for payment.

Seriously, address the lift pump NOW, before you have a problem because the few hundred you spend now will save you thousands in the long run. Price what rebuilding your injector pump costs.

That's a move up from your Uhaul conversion. :) Nice setup.

No direct experience but in general, short wheelbase trucks and heavy towing (above 4000 lbs) can be a little squirrelly, especially under braking. Then can tend to wag the dog, so to speak. You'll find most folks who tow heavy loads use long wheelbase trucks to combat the wag factor. You'll...

Pics on the beach look like Fiesta Island in San Diego. Loving the build.

Nicely done. Very clean and low profile. Only comment is on the E-track you used. You should be using the horizontal style (slots run 90* to what you have now). The clip in tie down points are not designed to be pulled from the side of the slot. They are to be pulled inline of the slot. If...

Yeah, I figured if I bought new studs, I could assemble the hubs/rotors and if I ran into problems, I didn't have the truck down. Also figured 150K miles on those stud, couldn't hurt to replace them. I actually didn't get the SS lines swapped in. On the driver side fitting, the hard lines T...

Thanks. U-joints look fine from the outside. Tight and no slop or clicking sounds. Only have 150,000 miles on the rig. As for a steering stablizer, I bought a Bilstein one from a guy who had upgraded his later model Ram (I think '06) to the '08+ style steering. I think I can make it work...

I never got around to posting this as I didn't realize I took pics. Found them last night so figured I would post up some work I did back in Oct. last year. After getting the steering linkage swapped in, during the alignment we found some issues with the brakes. I ended up replacing the hubs...

I'm actually kind of liking it. I think what will likely keep me out of it will be price. My guess is a loaded Trailhawk version will be close to $30K Guess we'll see.

Cool rig. Here is a link showing some pics I found on their FB page http://www.dutchiesgoglobal.com/panda-is-for-sale/ GLWS

I might be wrong but I thought the torsion bar helps to hold the weight of people sleeping in the overhead part. Those strut rods are to just keep it from bouncing when you move around. I think without the bar you're going to have major issues when you put any weight in the bed. At least that...

Great write up and pics. Thanks for sharing. Never get tired of DVNP area.

Flipac is not really "designed" to be removed and installed like a slide-in camper. Most people with Flipacs that don't build out the bed with storage and gear, typically have an empty bed and use the truck just like having a normal truck shell. In this form, you have to pack and unpack...

HitchGate by TireGate. Works great.

HitchGate by TireGate. Works great! Check my build thread for more pics.

Here's some from my recent trip. :)

Here's my '97 Dodge 2500 with a Cummins engine. I sit at about 8600 lbs and run a 285/75-16 tire and haven't had any place I have wanted to go, not able to. Here's a video of going up Mengal Pass in Death Valley. With a camper, I am not sure I would want any bigger then 35" but I don't...

I was out using mine this past weekend. :D

Great score.