Search results

Done. Good luck tonight!

@DieselRanger FYI, no pics in your post

you could, but (if i am understanding you) it would no longer protect the compressor. this is important protection to me. Over the past 11 years...mine has several scars there that would have demolished the air suspension. I just had mine off to reshape that section back to allow clearance. I...

Webster NY Land Rover did the same thing to one of mine 10 years ago.... :mad: The remaining bolts have held up, but I have heard of a local guy that could JB weld and tap new threads in mine.

Well done JWest! Pic 6 is impressive flex. Are you still using LLAMS electronic trickery or just GAP IID to set the height? What size are your BFG? Jason should give you some swag...I think you just sold us on the strut spacers.

For reference, I swapped out my HF 12K winch for a Warn VR12. The HF 15 sec use / 15 min cool down cycle was too limiting for me. I kept the HF mount and wireless controller.

Here it is: https://www.cars.com/vehicledetail/detail/743722647/overview/ About $5,500 over market compared to a similar cars (2014 RRS SC).

Good call on the 17"! Im heading the same path!! I know you already did the v6 brake reduction, but want to make the clear for any casual forum spectators.

Three different occasions come to mind...

wait, what? "one guy who jammed a Defender body on an LR4"??? links to pics?

Did these ever get created?

As my LR3 ages, I have often considered the same move. Really the 4runner is closer comparison to Discovery3/4.

I can roll slowly on my 275x65r18 Duratracs on the bumpstops.

Id sell you my 2006 w/locking rear diff for $20k too ;-)

Really nice looking ride. GLWTS

"Lowering the vehicle a bit for long highway drives " below the height when it was aligned, is a bad idea. You will eat tires faster than save gas.

The confusion is caused from the TD-V6 17" wheels. They require different rotors and caliper hangers front and back.

I have run three sets of 275/65r18 Duratracs at stock height LR3 without spacers. I had to ziptie the left front height sensor wire to the top of the frame. I have 3rd row heat/ac so it took 30min of light work. Right rear wheel well heaterhose had to be tucked in the body gap, the body seam...

I did just the rods for a while way back before IIDTOOL ever existed. Right or wrong, it is the defacto beginner mod. Scott's service department is GREAT and has never steered me wrong. "aesthetics" is a big part, but the rods allow for bigger diameter tires. Are you not seeing the...

Lots of trial-and-error. My adjustable rods have a turnbuckle (think thats the correct term). I dont remember exactly but after an alignment and height calibrations, I put it back in tight tolerance mode. Found the corner with the largest calibration factor and twisted 1 full turn and...