2001 Dodge Dakota Superduty Chassis swap camping rig build

[SDDiver5]

I grew up in a machine shop and I am a welder and equipment mechanic.

Well that certainly explains a lot lol

 

[mattcrouch1502]

On Christmas eve we were able to get the cab mounts burnt in. My son has done some small welding with me and this was a good chance for him to get more experience on his truck. He welded the flat section of the body mounts and I welded the verticals but first we had to get the frame low enough to get access to the top side. We jacked up the cab and then put stock wheels on the front to make some room.



A few pics of him burning wire.


The only pic of his weld that I remembered to get... He left a big gap between the tack and his bead, the bead looks pretty good and we ground the tack down and feathered the bead some and tied them together.


After getting everything welded up we set the cab back down and centered up, then he got to "drive" it some as I pushed it back into its spot.

 

[mattcrouch1502]

Somewhat productive weekend. Got the front frame horns chopped off, this was kind of fun thanks to the frame rail profile. What is interesting is the frame rails aren't symmetrical due to the power steering box. This made keeping the cuts even tricky but its not super critical as long as the new horns are square and level.

We then capped the end of frame rails to prepare for the new horns.

The new frame horns are 6"X2" rectangle tubing, I had this laying around from a bumper build and it seemed perfect for this. Currently the tubes were left long while we figure out how the bumper will be mounted up. Also the rusty square tube was just in there for welding.

Last thing we did before wrapping up was salvage the core support mounts from the Superduty horns and get one mocked up. The core support bolt will need to be changed a little due to clearance but that should be straight forward.